Hydrogen Delayed Fracture Properties and Internal Hydrogen Behavior of a Fe-18Mn-1.5Al-0.6C TWIP Steel

被引:174
作者
So, Kyoung Ho [1 ]
Kim, Ji Soo [1 ]
Chun, Young Soo [1 ]
Park, Kyung-Tae [2 ]
Lee, Young-Kook [3 ]
Lee, Chong Soo [1 ]
机构
[1] Pohang Univ Sci & Technol, Dept Mat Sci & Engn, Pohang 790784, South Korea
[2] Hanbat Natl Univ, Div Adv Mat Sci & Engn, Taejon 305719, South Korea
[3] Yonsei Univ, Dept Met Engn, Seoul 120749, South Korea
关键词
hydrogen delayed fracture; twin induced plasticity; hydrogen trapping site; thermal desorption analysis; HIGH-STRENGTH STEELS; ASSISTED CRACKING; TRIP/TWIP STEELS; THERMAL-ANALYSIS; TRIP STEEL; EMBRITTLEMENT; IRON; DEGRADATION; DUCTILE; METALS;
D O I
10.2355/isijinternational.49.1952
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The hydrogen delayed fracture (HDF) properties and internal hydrogen behavior were investigated in a Fe-18Mn-15Al-0.6C steel, a representative twinning induced plasticity (TWIP) aided steel. Slow strain rate tests (SSRT) were employed on both smooth and notched specimens to evaluate the effects of diffusible hydrogen on the HDF properties of the steel. Results showed that the fracture stress, fracture strain and time to fracture of the hydrogen pre-charged specimens were relatively insensitive to the amount of diffusible hydrogen. Fracture surface exhibited a ductile dimple fracture mode regardless of the diffusible hydrogen concentration. It was found that most hydrogen became non-diffusible after SSRT The major trapping sites of hydrogen were dislocations, grain boundaries and twins. The activation energies for detrapping of hydrogen were estimated 35 kJ/mol for dislocations or grain boundaries, and 62 kJ/mol for twins. A comparison of the HDF properties of the present steel with those of other high strength steels revealed that the TWIP steel appeared to be relatively immune to hydrogen delayed fracture. This was due to the combined effects of (a) higher hydrogen solubility of austenite matrix (b) negligible portion of diffusible hydrogen to the total hydrogen, (c) decrease of diffusible hydrogen content during the deformation, and (d) no transformation of austenite to either epsilon or alpha' martensite.
引用
收藏
页码:1952 / 1959
页数:8
相关论文
共 30 条
[1]   Modeling of mechanical twinning in a high manganese content austenitic steel [J].
Allain, S ;
Chateau, JP ;
Dahmoun, D ;
Bouaziz, O .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2004, 387 :272-276
[2]  
[Anonymous], 2002, ANAL ANAL CHEM, DOI DOI 10.1021/AC60131A045
[3]   ENVIRONMENT-ASSISTED CRACKING OF FE-32-PERCENT MN-9-PERCENT AL-ALLOYS IN 3.5-PERCENT SODIUM-CHLORIDE SOLUTION [J].
CHANG, SC ;
LIU, JY ;
JUANG, HK .
CORROSION, 1995, 51 (05) :399-406
[4]   THERMAL-ANALYSIS OF TRAPPED HYDROGEN IN PURE IRON [J].
CHOO, WY ;
LEE, JY .
METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1982, 13 (01) :135-140
[5]  
CORNETTE D, 2005, REV METALLURGIE, V12, P905
[6]   Supra-ductile and high-strength manganese-TRIP/TWIP steels for high energy absorption purposes [J].
Frommeyer, G ;
Brüx, U ;
Neumann, P .
ISIJ INTERNATIONAL, 2003, 43 (03) :438-446
[7]  
GOLD E, 1969, ASM TRANS Q, V62, P607
[8]   High strength Fe-Mn-(Al, Si) TRIP/TWIP steels development -: properties -: application [J].
Grässel, O ;
Krüger, L ;
Frommeyer, G ;
Meyer, LW .
INTERNATIONAL JOURNAL OF PLASTICITY, 2000, 16 (10-11) :1391-1409
[9]   Optimization of corrosion protection potential for stress corrosion cracking and hydrogen embrittlement of 5083-H112 alloy in Seawater [J].
Han, Min-Su ;
Ko, Seokcheol ;
Kim, Sang-Hyun ;
Jang, Seok-Ki ;
Kim, Seong-Jong .
METALS AND MATERIALS INTERNATIONAL, 2008, 14 (02) :203-211
[10]   1980 INSTITUTE OF METALS LECTURE THE METALLURGICAL-SOCIETY-OF-AIME - EFFECTS OF HYDROGEN ON THE PROPERTIES OF IRON AND STEEL [J].
HIRTH, JP .
METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1980, 11 (06) :861-890