Calcination temperature dependence of synthesis process and hydrogen sensing properties of In-doped CaZrO3

被引:16
作者
Chen, Jianxun [1 ]
Wu, Shusen [1 ]
Zhang, Feng [1 ]
Lu, Shulin [1 ]
Mao, Youwu [1 ]
机构
[1] Huazhong Univ Sci & Technol, State Key Lab Mat Proc & Die & Mould Technol, Wuhan 430074, Peoples R China
关键词
Ceramics; Differential thermal analysis (DTA); Powder diffraction; Electrochemical properties; SOLID-ELECTROLYTE; PROTON; CAZR0.90IN0.10O3-DELTA; CONDUCTION; CERAMICS; SYSTEM;
D O I
10.1016/j.matchemphys.2015.12.064
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The CaZr0.9In0.1O3-delta can be used as solid electrolyte material for high temperature hydrogen sensors. In this paper, thermogravimetric-differential thermal analysis and X-ray diffractometer analysis were employed to investigate the calcination temperature dependence of fabricating this material. The results show that CaZrO3 matrix phase can be synthesized directly by CaO and ZrO2 at 1000 degrees C or stepwise by intermediate oxide CaZr4O9 at higher temperatures between 1000 degrees C and 1200 degrees C during solid-state reaction process. Doping of indium into CaZrO3 occurs in the temperature range of 1200 degrees C-1400 degrees C. With calcination temperature exceeding 1400 degrees C, no obvious improvement of doping occurs. Even a sharp deterioration of doping effect happens with a temperature of 1550 degrees C. The CaZr0.9In0.1O3-delta electrolyte powders with a main phase purity of 98.75% were synthesized at 1400C for 10 h. The electrolyte tubes with a relative density of 96.8% and a homogeneous crystal size between 2 mu m and 3 mu m are fabricated out. Hydrogen sensor assembled with the electrolyte tube exhibits good hydrogen sensing performance obeying the Nernst law at 700 degrees C-800 degrees C. (C) 2016 Elsevier B.V. All rights reserved.
引用
收藏
页码:87 / 97
页数:11
相关论文
共 28 条
[1]   CRYSTAL CHEMISTRY OF INDATES - CALCIUM, CADMIUM, STRONTIUM AND BARIUM INDATES [J].
CRUICKSHANK, FR ;
TAYLOR, DM ;
GLASSER, FP .
JOURNAL OF INORGANIC & NUCLEAR CHEMISTRY, 1964, 26 (06) :937-941
[2]   Hydrogen sensor based on oxide proton conductors and its application to metallurgical engineering [J].
Fukatsu, N ;
Kurita, N .
IONICS, 2005, 11 (1-2) :54-65
[3]   Fabrication of dense CaZr0.90In0.10O3-δ ceramics from the fine powders prepared by an optimized solid-state reaction method [J].
Han, Jinduo ;
Wen, Zhaoyin ;
Zhang, Jingchao ;
Gu, Zhonghua ;
Xu, Xiaohe .
SOLID STATE IONICS, 2008, 179 (21-26) :1108-1111
[4]   Synthesis and characterization of proton conductive CaZr0.90In0.10O3-δ by a citric acid complexation method [J].
Han, Jinduo ;
Wen, Zhaoyin ;
Zhang, Jingchao ;
Xu, Xiaohe ;
Gu, Zhonghua ;
Liu, Yu .
FUSION ENGINEERING AND DESIGN, 2010, 85 (10-12) :2100-2104
[5]   Electrical conductivity of fully densified nano CaZr0.9In0.10O3-δ ceramics prepared by a water-based gel precipitation method [J].
Han, Jinduo ;
Wen, Zhaoyin ;
Zhang, Jingchao ;
Wu, Xiangwei ;
Lin, Bin .
SOLID STATE IONICS, 2009, 180 (2-3) :154-159
[6]   The zirconium/hydrogen system as the solid-state reference of a high-temperature proton conductor-based hydrogen sensor [J].
Hills, M. P. ;
Schwandt, C. ;
Kumar, R. V. .
JOURNAL OF APPLIED ELECTROCHEMISTRY, 2011, 41 (05) :499-506
[7]   Ab initio calculations of elastic modulus and electronic structures of cubic CaZrO3 [J].
Hou, Z. F. .
PHYSICA B-CONDENSED MATTER, 2008, 403 (17) :2624-2628
[8]  
Igor L., 2003, J SOLID STATE CHEM, V175, P170
[9]   Proton migration and defect interactions in the CaZrO3 orthorhombic perovskite:: A quantum mechanical study [J].
Islam, MS ;
Davies, RA ;
Gales, JD .
CHEMISTRY OF MATERIALS, 2001, 13 (06) :2049-2055
[10]   Introduction of In or Ga as second dopant to BaZr0.9Y0.1O3-δ to achieve better sinterability [J].
Ito, Naoki ;
Matsumoto, Hiroshige ;
Kawasaki, Yuya ;
Okada, Sachio ;
Ishihara, Tatsumi .
SOLID STATE IONICS, 2008, 179 (9-10) :324-329