Friction stir lap welding of stainless steel and plain carbon steel to enhance corrosion properties

Friction stir lap welding-a precursor to the friction stir cladding-stainless steel on plain carbon steel was attempted. Refined microstructure with fully recrystallized austenitic grains with similar to 3 mu m grain size and intermixing with base steel sample resulted in defect free lap weld. The pin affected region of the base carbon steel resulted in grain refinement from initial grain size of 8 mu m to 2 mu m. The microhardness values across the joint line showed stable values of similar to 250 HV on the stainless steel side and similar to 200 HV on the carbon steel side. Lap shear tests showed consistent load bearing capacity of similar to 7 kN for the stainless steel-carbon steel joint. The weld between stainless steel and carbon steel showed 100% joint efficiency with similar yield strength of similar to 440 MPa as the base steel sample and with an increase in ultimate tensile strength to similar to 600 MPa as compared to similar to 500 MPa for the base steel sample. The failure of clad tensile samples occurred in the base steel plate. Corrosion characterization of the clad surface was conducted in 3.5 wt.% sodium chloride solution. The potentiodynamic polarization showed positive corrosion potentials with a large passive range of similar to 500 mV for the clad surface and a decrease in corrosion rates by more than an order as compared to the base steel sample. The friction stir lap welded stainless showed similar electrochemical properties as of the base stainless steel sheet.