Mechanical confinement for improved energy storage density in BNT-BT-KNN lead-free ceramic capacitors

With the advent of modern power electronics, embedded circuits and non-conventional energy harvesting, the need for high performance capacitors is bound to become indispensible. The current state-of-art employs ferroelectric ceramics and linear dielectrics for solid state capacitance. However, lead-free ferroelectric ceramics propose to offer significant improvement in the field of electrical energy storage owing to their high discharge efficiency and energy storage density. In this regards, the authors have investigated the effects of compressive stress as a means of improving the energy storage density of lead-free ferroelectric ceramics. The energy storage density of 0.91(Bi0.5Na0.5)TiO3-0.07BaTiO(3)-0.02(K0.5Na0.5)NbO3 ferroelectric bulk ceramic was analyzed as a function of varying levels of compressive stress and operational temperature. It was observed that a peak energy density of 387 mJ.cm(-3) was obtained at 100 MPa applied stress (25 degrees C). While a maximum energy density of 568 mJ.cm(-3) was obtained for the same stress at 80 degrees C. These values are indicative of a significant, 25% and 84%, improvement in the value of stored energy compared to an unloaded material. Additionally, material's discharge efficiency has also been discussed as a function of operational parameters. The observed phenomenon has been explained on the basis of field induced structural transition and competitive domain switching theory. (C) 2014 Author(s). All article content, except where otherwise noted, is licensed under a Creative Commons Attribution 3.0 Unported License.