Aerodynamic characteristics of morphing wing with flexible leading-edge

被引:45
作者
Kan, Zi [1 ]
Li, Daochun [1 ]
Shen, Tong [1 ]
Xiang, Jinwu [1 ]
Zhang, Lu [1 ]
机构
[1] Beihang Univ, Sch Aeronaut Sci & Engn, Beijing 100083, Peoples R China
关键词
Aerodynamics; Computational fluid dynamics; Flexible leading-edge; Morphing wings; Stall angle; TIP DEMONSTRATOR; TUNNEL TESTS; OPTIMIZATION; VALIDATION; AIRFOILS; DESIGN;
D O I
10.1016/j.cja.2020.03.012
中图分类号
V [航空、航天];
学科分类号
08 ; 0825 ;
摘要
The morphing wing can improve the flight performance during different phases. However, research has been subject to limitations in aerodynamic characteristics of the morphing wing with a flexible leading-edge. The computational fluid dynamic method and dynamic mesh were used to simulate the continuous morphing of the flexible leading-edge. After comparing the steady aerodynamic characteristics of morphing and conventional wings, this study examined the unsteady aerodynamic characteristics of morphing wings with upward and downward deflections of the leading-edge at different frequencies. The numerical results show that for the steady aerodynamic, the leading-edge deflection mainly affects the stall characteristic. The downward deflection of the leading-edge increases the stall angle of attack and nose-down pitching moment. The results are opposite for the upward deflection. For the unsteady aerodynamic, at a small angle of attack, the transient lift coefficient of the upward deflection, growing with the increase of deflection frequency, is larger than that of the static case. The transient lift coefficient of the downward deflection, decreasing with the increase of deflection frequency, is smaller than that of the static case. However, at a large angle of attack, an opposite effect of deflection frequency on the transient lift coefficient was demonstrated. The transient lift coefficient is larger than that of the static case when the leading edge is in the nose-up stage, and lower than that of the static one in the nose-down stage. (C) 2020 Production and hosting by Elsevier Ltd. on behalf of Chinese Society of Aeronautics and Astronautics.
引用
收藏
页码:2610 / 2619
页数:10
相关论文
共 22 条
[1]   Morphing airfoils analysis using dynamic meshing [J].
Abdessemed, Chawki ;
Yao, Yufeng ;
Bouferrouk, Abdessalem ;
Narayan, Pritesh .
INTERNATIONAL JOURNAL OF NUMERICAL METHODS FOR HEAT & FLUID FLOW, 2018, 28 (05) :1117-1133
[2]  
Ai Q., 2016, 54 AIAA AER SCI M, P1
[3]  
Amenturi S., 2018, MORPHING WING TECHNO, P491, DOI DOI 10.1016/B978-0-08-100964-2.00016-2
[4]  
Carr L.W., 1982, An experimental study of dynamic stall on advanced airfoil sections
[5]  
Cheung RC, 2015, INT FOR AER STRUCT D, P1
[6]   Numerical simulation and wind tunnel tests investigation and validation of a morphing wing-tip demonstrator aerodynamic performance [J].
Gabor, Oliviu Sugar ;
Koreanschi, Andreea ;
Botez, Ruxandra Mihaela ;
Mamou, Mahmoud ;
Mebarki, Youssef .
AEROSPACE SCIENCE AND TECHNOLOGY, 2016, 53 :136-153
[7]   Experimental and finite element analyses of multifunctional skins for morphing wing applications [J].
Geier, Sebastian ;
Kintscher, Markus ;
Mahrholz, Thorsten ;
Wierach, Peter ;
Monner, Hans-Peter ;
Wiedemann, Martin .
SENSORS AND SMART STRUCTURES TECHNOLOGIES FOR CIVIL, MECHANICAL, AND AEROSPACE SYSTEMS 2016, 2016, 9803
[8]   Experimental and numerical investigation of aerodynamic performance for airfoils with morphed trailing edges [J].
Jawahar, Hasan Kamliya ;
Ai, Qing ;
Azarpeyvand, Mandi .
RENEWABLE ENERGY, 2018, 127 :355-367
[9]  
Kaul U.K., 2014, P 32 AIAA APPL AER C, P1
[10]  
Kintscher M, 2016, ECCOMAS2016 7 EUR C