MOFs in carbon capture-past, present and future

被引:87
作者
Aniruddha, R. [1 ]
Sreedhar, I [1 ]
Reddy, Benjaram M. [2 ]
机构
[1] Dept Chem Engn, BITS Pilani Hyderabad Campus, Hyderabad 500078, India
[2] CSIR, Catalysis & Fine Chem Dept, Indian Inst Chem Technol, Uppal Rd, Hyderabad 500007, India
关键词
MOFs in carbon capture; Synthesis protocol; Capture capacity comparative analysis; Computational modelling; Contactors; Morphology and screening; METAL-ORGANIC-FRAMEWORK; HIGHLY SELECTIVE ADSORPTION; MIXED-MATRIX MEMBRANES; COMBUSTION CO2 CAPTURE; DIOXIDE CAPTURE; SWING ADSORPTION; GAS-ADSORPTION; MODULATED SYNTHESIS; ADSORBENT MATERIALS; CO2/N-2; SEPARATION;
D O I
10.1016/j.jcou.2020.101297
中图分类号
O6 [化学];
学科分类号
0703 ;
摘要
Metal Organic Frame works (MOFs) are being widely used in carbon capture through adsorption and membrane techniques, which are yet to be commercialized. This is due to their high affinity towards acidic gases and exceptional characteristics such as crystallinity, structural stability, high surface area and flexible pore dimensions. In this review, wide range of topics viz., synthesis protocols, modifications employed to further improve their attributes, comprehensive comparison of different MOFs used in carbon capture, thermo-kinetics modelling studies, contactors and material screening. Every section has been discussed in detail in terms of developmental trends, future challenges and prospects besides summarizing in the form of comprehensive tables at a glance for the benefit of the readers. Solvo-thermal method was found to be the most effective synthesis method besides ultra-sonication and microwave assisted methods, which also gave very good crystalline structures. The copper ligand based unmodified Cu-BTC MOF gave the maximum CO2 uptake value of 9.59 mmol/g at 273 K and 1 atm. Zn(Bmic)(AT) MOF was the only species to be tested at 353 K. Alternatively, a photo-responsive MOF, Mg-IRMOF-74-III functionalized with azopyridine gave a CO2 uptake of 89 cc/g which is comparable to many of the conventional MOFs. Kinetics indicate MOF adsorption mostly follows pseudo second order reactions either along with Toth isotherms or modified Langmuir isotherms. Fixed and fluidized bed reactors perform the best in terms of carbon capture studies. Moisture affinity, active sites and crystallinity were found to be the best factors considered whilst screening of proper MOFs.
引用
收藏
页数:27
相关论文
共 238 条
[1]   [Cu3(BTC)2]-polyethyleneimine: an efficient MOF composite for effective CO2 separation [J].
Aarti ;
Bhadauria, Sonal ;
Nanoti, Anshu ;
Dasgupta, Soumen ;
Divekar, Swapnil ;
Gupta, Pushpa ;
Chauhan, Rekha .
RSC ADVANCES, 2016, 6 (95) :93003-93009
[2]   Morphology- and size-controlled synthesis of a metal-organic framework under ultrasound irradiation: An efficient carrier for pH responsive release of anti-cancer drugs and their applicability for adsorption of amoxicillin from aqueous solution [J].
Abazari, Reza ;
Mahjoub, Ali Reza ;
Slawin, Alexandra M. Z. ;
Carpenter-Warren, Cameron L. .
ULTRASONICS SONOCHEMISTRY, 2018, 42 :594-608
[3]   Zinc hydroxide nitrate nanosheets conversion into hierarchical zeolitic imidazolate frameworks nanocomposite and their application for CO2 sorption [J].
Abdelhamid, H. N. .
MATERIALS TODAY CHEMISTRY, 2020, 15
[4]   Bimetallic Ni-Co-based metal-organic framework: An open metal site adsorbent for enhancing CO2 capture [J].
Abdoli, Yekta ;
Razavian, Marjan ;
Fatemi, Shohreh .
APPLIED ORGANOMETALLIC CHEMISTRY, 2019, 33 (08)
[5]   Sonochemical synthesis and structural characterization of a new Zn(II) nanoplate metal-organic framework with removal efficiency of Sudan red and Congo red [J].
Abdollahi, Nasrin ;
Masoomi, Mohammad Yaser ;
Morsali, Ali ;
Junk, Peter C. ;
Wang, Jun .
ULTRASONICS SONOCHEMISTRY, 2018, 45 :50-56
[6]   Boosting CO2 adsorption and selectivity in metal-organic frameworks of MIL-96(Al) via second metal Ca coordination [J].
Abid, Hussein Rasool ;
Rada, Zana Hassan ;
Li, Yuan ;
Mohammed, Hussein A. ;
Wang, Yuan ;
Wang, Shaobin ;
Arandiyan, Hamidreza ;
Tan, Xiaoyao ;
Liu, Shaomin .
RSC ADVANCES, 2020, 10 (14) :8130-8139
[7]  
Aghajanloo M., 2014, J CHEM ENG PROCESS T
[8]   Design and synthesis of porous polymeric materials and their applications in gas capture and storage: a review [J].
Ahmed, Dina S. ;
El-Hiti, Gamal A. ;
Yousif, Emad ;
Ali, Ali A. ;
Hameed, Ayad S. .
JOURNAL OF POLYMER RESEARCH, 2018, 25 (03) :1-21
[9]   Post-combustion CO2 capture with activated carbons using fixed bed adsorption [J].
Al Mesfer, Mohammed K. ;
Danish, Mohd ;
Fahmy, Yasser M. ;
Rashid, Md. Mamoon .
HEAT AND MASS TRANSFER, 2018, 54 (09) :2715-2724
[10]   Guidelines for the use and interpretation of adsorption isotherm models: A review [J].
Al-Ghouti, Mohammad A. ;
Da'ana, Dana A. .
JOURNAL OF HAZARDOUS MATERIALS, 2020, 393