Performance analysis of a dielectric based 3D building integrated concentrating photovoltaic system

被引:87
作者
Baig, Hasan [1 ]
Sellami, Nazmi [1 ]
Chemisana, Daniel [2 ]
Rosell, Joan [2 ]
Mallick, Tapas K. [1 ]
机构
[1] Univ Exeter, Environm & Sustainabil Inst, Penryn TR10 9FE, Cornwall, England
[2] Univ Lleida, Lleida, Spain
基金
英国工程与自然科学研究理事会;
关键词
3DCCPC; Non-uniform; CPV; BiCPV; CPC; COMPOUND PARABOLIC CONCENTRATOR; SOLAR-CELLS; MODULES;
D O I
10.1016/j.solener.2014.03.002
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
The use of concentrating photovoltaic systems (CPV) in building integration has spurred towards the development of newer products, which have the potential to offer the convenience of pleasing architecture and day lighting along with simultaneous production of clean energy. This paper addresses the energy transformations and the expected energy output of a low concentrating photovoltaic system designed to have a geometric concentration of 3.6 x. The optical element used is a three dimensional Cross Compound Concentrator (3DCCPC) made from clear polyurethane material. Small sized silicon solar cells based on the Laser Grooved Buried Contact (LGBC) technology having an absorber area of 1 cm(2) are utilised in the system. Both experimental and numerical analyses are performed confirming the optical, electrical and thermal performance of the system. While performing the optical analysis the concentrator was found to have a maximum optical efficiency of 73.4%. A maximum power ratio of 2.67 was observed when comparing the electrical output of the concentrator unit with a non-concentrating counterpart. The effects of non-uniformity caused by the use of the concentrator are analysed. The non-uniformity of flux distribution showed an average drop of 2.2% in the I-sc values which is again reflected in the overall power output. Manufacturing defects like the cell and concentrator misalignments are addressed and their impact on the overall performance are verified by numerical simulations. The operating temperature of the solar cells was found to have a parasitic effect on the overall performance of the system. A maximum temperature of 332 K was observed in the solar cell at 0 degrees incidence and a incoming radiation of 1000 W/m(2) which brings down the overall power production by 14.6%. Finally, the expected system output over a given time period is presented showing the strengths and weakness while employing such a system. (C) 2014 Elsevier Ltd. All rights reserved.
引用
收藏
页码:525 / 540
页数:16
相关论文
共 30 条
  • [21] Evaluation and optimization of the optical performance of low-concentrating dielectric compound parabolic concentrator using ray-tracing methods
    Sarmah, Nabin
    Richards, Bryce S.
    Mallick, Tapas K.
    [J]. APPLIED OPTICS, 2011, 50 (19) : 3303 - 3310
  • [22] Sellami N., 2011, INT REN EN C IREC201, P321
  • [23] Sellami N., 2011, PHOT SCI TECHN C ED
  • [24] Sellami N., 2012, 8 INT C CONC PHOT SY
  • [25] Optical efficiency study of PV Crossed Compound Parabolic Concentrator
    Sellami, Nazmi
    Mallick, Tapas K.
    [J]. APPLIED ENERGY, 2013, 102 : 868 - 876
  • [26] The Fresnel lens concept for solar control of buildings
    Tripanagnostopoulos, Y.
    Siabekou, Ch.
    Tonui, J. K.
    [J]. SOLAR ENERGY, 2007, 81 (05) : 661 - 675
  • [27] Tripanagnostopoulos Y., 2009, CONCENTRATING PHOTOV
  • [28] Performance of see-through prism CPV module for window integrated photovoltaics
    Yamada, Noboru
    Kanno, Kosuke
    Hayashi, Kentaro
    Tokimitsu, Toru
    [J]. OPTICS EXPRESS, 2011, 19 (14): : A649 - A656
  • [29] Practical application of building integrated photovoltaic (BIPV) system using transparent amorphous silicon thin-film PV module
    Yoon, Jong-Ho
    Song, Jonghwa
    Lee, Sung-Jin
    [J]. SOLAR ENERGY, 2011, 85 (05) : 723 - 733
  • [30] Linear dielectric non-imaging concentrating covers for PV integrated building facades
    Zacharopoulos, A
    Eames, PC
    McLarnon, D
    Norton, B
    [J]. SOLAR ENERGY, 2000, 68 (05) : 439 - 452