Sol gel deposited Sb doped SnO2 as transparent anode for OLED:: process, patterning and hole injection characteristics

被引：1
|
作者：
Vaufrey, D [1 ]
Ben Khalifa, M [1 ]
Besland, MP [1 ]
Sandu, C [1 ]
Blanchin, MG [1 ]
Teodorescu, V [1 ]
Roger, JA [1 ]
Tardy, J [1 ]
机构：
[1] Ecole Cent Lyon, Lab Elect Optoelect & Microsyst, CNRS, UMR 5512, F-69131 Ecully, France
来源：
ORGANIC LIGHT-EMITTING MATERIALS AND DEVICES V | 2002年 / 4464卷
关键词：
SnO2; sol-gel; RIE; OLED;
D O I：
10.1117/12.457464
中图分类号：
O43 [光学];
学科分类号：
070207 ; 0803 ;
摘要：
This paper reports on the potentialities of sol-gel deposited Sb doped SnO2 (TO) as a new transparent conducting oxide (TCO) for anode in organic light emitting diodes (OLED). Multilayered films with transparency over 85% and resistivity lower than 5 10(-3) Omega-cm were obtained. Structural observations by Transmission Electron Microscopy (TEM) show that the films are nanocrystallized. Smaller and more uniform grains are obtained upon rapid thermal annealing. Atomic Force Microscopy (AIM) imaging shows the surface roughness does not exceed 20 Angstrom. TO films are very stable and cannot be chemically etched. Anode patterning by reactive ion etching (RIE) in a Methane-Hydrogen plasma has been experienced and is described. Typical etching around 250 Angstrom/min were obtained. TO/PEDOT/PVK/Al hole only diodes were realized to assess sot gel TO films as hole injection electrodes. Devices with threshold voltages of 6 volts were obtained. A comparison with ITO deposited by low temperature cathodic sputtering is given.
引用
收藏
页码：103 / 112
页数：10
相关论文
共 50 条
  • [1] Specific properties of undoped and Sb doped sol-gel deposited SnO2 layers
    Chatelon, JP
    Terrier, C
    Blanchin, MG
    Mugnier, J
    Roger, JA
    PROCEEDINGS OF THE 13TH INTERNATIONAL CONFERENCE ON DEFECTS IN INSULATING MATERIALS - ICDIM 96, 1997, 239- : 81 - 86
  • [2] Impedance studies of Sb doped SnO2 thin film prepared by sol gel process
    Benrabah, B.
    Bouaza, A.
    Kadari, A.
    Maaref, M. A.
    SUPERLATTICES AND MICROSTRUCTURES, 2011, 50 (06) : 591 - 600
  • [3] SnO2:Sb transparent conducting coatings made by different sol-gel processes
    Gasparro, G
    Ganz, D
    Gobbert, C
    Putz, J
    Aegerter, MA
    SOL-GEL OPTICS IV, 1997, 3136 : 407 - 418
  • [4] Laser sintering of SnO2:Sb sol-gel coatings
    Ganz, D
    Gasparro, G
    Aegerter, MA
    JOURNAL OF SOL-GEL SCIENCE AND TECHNOLOGY, 1998, 13 (1-3) : 961 - 967
  • [5] Laser Sintering of SnO2 : Sb Sol-Gel Coatings
    D. Ganz
    G. Gasparro
    M.A. Aegerter
    Journal of Sol-Gel Science and Technology, 1998, 13 : 961 - 967
  • [6] Fine pattern fabrication on SnO2:: Sb thin films formed by the sol-gel process
    Li, Ying
    Zhao, Gaoyang
    Zhang, Weihua
    Chen, Yuanqing
    SURFACE AND INTERFACE ANALYSIS, 2006, 38 (09) : 1291 - 1295
  • [7] Optical and electrochemical properties of SnO2:Sb thin films prepared by the sol-gel process
    Sentanin, FC
    Pawlicka, A
    Avellaneda, CO
    MOLECULAR CRYSTALS AND LIQUID CRYSTALS, 2006, 447 (243/[561]-250/[568]) : 561 - 568
  • [8] Excimer Laser Crystallization of SnO2:Sb Sol-Gel Films
    C.S. Sandu
    V.S. Teodorescu
    C. Ghica
    P. Hoffmann
    T. Bret
    A. Brioude
    M.G. Blanchin
    J.A. Roger
    B. Canut
    M. Croitoru
    Journal of Sol-Gel Science and Technology, 2003, 28 : 227 - 234
  • [9] Excimer laser crystallization of SnO2:Sb sol-gel films
    Sandu, CS
    Teodorescu, VS
    Ghica, C
    Hoffmann, P
    Bret, T
    Brioude, A
    Blanchin, MG
    Roger, JA
    Canut, B
    Croitoru, M
    JOURNAL OF SOL-GEL SCIENCE AND TECHNOLOGY, 2003, 28 (02) : 227 - 234
  • [10] Mn DOPED SnO2 PREPARED BY A SOL-GEL METHOD
    Ungureanu, Ana-Maria
    Jitaru, Ioana
    Gosnea, Florinela
    UNIVERSITY POLITEHNICA OF BUCHAREST SCIENTIFIC BULLETIN SERIES B-CHEMISTRY AND MATERIALS SCIENCE, 2013, 75 (03): : 43 - 52
12345