The Effects of Changing Fuels on Hot Gas Path Conditions in Syngas Turbines

被引:4
|
作者
Sabau, Adrian S. [1 ]
Wright, Ian G. [1 ]
机构
[1] Oak Ridge Natl Lab, Mat & Sci & Technol Div, Oak Ridge, TN 37831 USA
来源
JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME | 2009年 / 131卷 / 04期
关键词
blades; combined cycle power stations; combustion; compressors; coolants; cooling; gas turbines; thermodynamics; BLADE;
D O I
10.1115/1.3028566
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
Gas turbines in integrated gasification combined cycle power plants burn a fuel gas (syngas (SG)) in which the proportions of hydrocarbons, H(2), CO, water vapor, and minor impurity levels may differ significantly from those in natural gas (NG). Such differences can yield changes in the temperature, pressure, and corrosive species that are experienced by critical components in the hot gas path, with important implications for the design, operation, and reliability of the turbine. A new data structure and computational methodology is presented for the numerical simulation of a turbine thermodynamic cycle, with emphasis on the hot gas path components. The approach used allows efficient handling of turbine components and variable constraints due to fuel changes. Examples are presented for a turbine with four stages, in which the vanes and blades are cooled in an open circuit using air from the appropriate compressor stages. For an imposed maximum metal temperature, values were calculated for the fuel, air, and coolant flow rates and through-wall temperature gradients for cases where the turbine was fired with NG or SG. A NG case conducted to assess the effect of coolant pressure matching between the compressor extraction points and corresponding turbine injection points indicated that this is a feature that must be considered for high combustion temperatures. The first series of SG simulations was conducted using the same inlet mass flow and pressure ratios as those for the NG case. The results showed that higher coolant flow rates and a larger number of cooled turbine rows were needed for the SG case to comply with the imposed temperature constraints. Thus, for that case, the turbine size would be different for SG than for NG. A second series of simulations examined scenarios for maintaining the original turbine configuration (i.e., geometry, diameters, blade heights, angles, and cooling circuit characteristics) used for the SG simulations. In these, the inlet mass flow was varied while keeping constant the pressure ratios and the amount of hot gas passing the first vane of the turbine. The effects of turbine matching between the NG and SG cases were increases-for the SG case of approximately 7% and 13% for total cooling flows and cooling flows for the first-stage vane, respectively. In particular, for the SG case, the vanes in the last stage of the turbine experienced inner wall temperatures that approached the maximum allowable limit.
引用
收藏
页数:7
相关论文
共 50 条
  • [1] GAS TURBINES FIRED WITH BIOMASS PYROLYSIS SYNGAS: ANALYSIS OF THE OVERHEATING OF HOT GAS PATH COMPONENTS
    Colantoni, Simone
    Della Gatta, Stefania
    De Prosperis, Roberto
    Russo, Alessandro
    Desideri, Umberto
    Fantozzi, Francesco
    PROCEEDINGS OF THE ASME TURBO EXPO 2009, VOL 1, 2009, : 389 - 398
  • [2] Gas Turbines Fired With Biomass Pyrolysis Syngas: Analysis of the Overheating of Hot Gas Path Components
    Colantoni, Simone
    Della Gatta, Stefania
    De Prosperis, Roberto
    Russo, Alessandro
    Fantozzi, Francesco
    Desideri, Umberto
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2010, 132 (06): : 1 - 8
  • [3] Numerical simulations of the effects of changing fuel for turbines fired by natural gas and syngas
    Sabau, Adrian S.
    Wright, Ian G.
    PROCEEDINGS OF THE ASME TURBO EXPO, VOL 2, 2007, : 413 - 422
  • [4] Advanced fuels for gas turbines: Fuel system corrosion, hot path deposit formation and emissions
    Seljak, Tine
    Sirok, Brane
    Katrasnik, Tomaz
    ENERGY CONVERSION AND MANAGEMENT, 2016, 125 : 40 - 50
  • [5] Combustion of syngas in gas turbines
    Huth, M
    Vortmeyer, N
    Schetter, B
    Karg, J
    BRENNSTOFF-WARME-KRAFT, 1998, 50 (09): : 35 - +
  • [6] Life management system for hot-gas-path components of gas turbines
    Hayasaka, Y
    Isobe, N
    Sakurai, S
    Kumada, K
    ADVANCES IN TURBINE MATERIALS, DESIGN AND MANUFACTURING, 1997, : 653 - 662
  • [7] Analysis of main gaseous emissions of heavy duty gas turbines burning several syngas fuels
    Chacartegui, R.
    Torres, M.
    Sanchez, D.
    Jimenez, F.
    Munoz, A.
    Sanchez, T.
    FUEL PROCESSING TECHNOLOGY, 2011, 92 (02) : 213 - 220
  • [8] FUELS FOR MARINE GAS TURBINES
    CABAL, AV
    WARREN, JH
    MECHANICAL ENGINEERING, 1967, 89 (07) : 66 - &
  • [9] Gas Turbines for the Fuels of the Future
    Koenemann, Detlef
    BWK, 2011, 63 (06): : 71 - 75
  • [10] Performance of gas turbines in Russia under the changing climatic conditions
    Klimenko V.V.
    Klimenko A.V.
    Kasilova E.V.
    Rekunenko E.S.
    Tereshin A.G.
    Thermal Engineering, 2016, 63 (10) : 690 - 698