Flow behavior control in immersion lithography

Over the past decade, immersion lithography has been the primary technology for exposure process in semiconductor manufacturing. Compared with traditional dry lithography method, this technology improves the exposure resolution greatly by inserting a high index liquid into the gap between lens and wafer surface. Keeping the immersion liquid pure and uniform as well as avoiding residual droplets during high speed scanning motion are two challenges faced by the development of immersion lithography. Contaminations, particles, bubbles, heating and stress in the liquid will destroy the continuity of the refractive index. High speed motion of the wafer during scanning may break the meniscus stability on the interface between the liquid and the gas surrounding it, and then generate residual droplets on the wafer. All above phenomena will affect the exposure performance of immersion lithography and corresponding flow behavior control methods are required to solve the problems. This paper gives a review of the studies on flow behavior control in immersion lithography, which contains two parts: studies for liquid purity and uniformity and studies for meniscus stability. In each part, the mechanism and character of the flow behaviors as well as their effects to exposure performance are presented firstly. Then, control approaches adopted by now, including material and surface modifications as well as immersion head utilization, are introduced. In addition, the challenges faced in future studies are also pointed out. The purpose of this review paper is to help the researchers to understand the flow control problems in immersion lithography and to provide better control approaches for exposure performance improvement. (C) 2016 Elsevier Ltd. All rights reserved.