Uranium-zirconium hydride fuel properties

Properties of the two-phase hydride U0.3ZrH1.6 pertinent to performance as a nuclear fuel for LWRs are reviewed. Much of the available data come from the Space Nuclear Auxiliary Power (SNAP) program of 4 decades ago and from the more restricted data base prepared for the TRIGA research reactors some 3 decades back. Transport, mechanical, thermal and chemical properties are summarized. A principal difference between oxide and hydride fuels is the high thermal conductivity of the latter. This feature greatly decreases the temperature drop over the fuel during operation, thereby reducing the release of fission gases to the fraction due only to recoil. However, very unusual early swelling due to void formation around the uranium particles has been observed in hydride fuels. Avoidance of this source of swelling limits the maximum fuel temperature to similar to 650 degrees C (the design limit recommended by the fuel developer is 750 degrees C). To satisfy this temperature limitation, the fuel-cladding gap needs to be bonded with a liquid metal instead of helium. Because the former has a thermal conductivity -100 times larger than the latter, there is no restriction on gap thickness as there is in helium-bonded fuel rods. This opens the possibility of initial gap sizes large enough to significantly delay the onset of pellet-cladding mechanical interaction (PCMI). The large fission-product swelling rate of hydride fuel (3x that of oxide fuel) requires an initial radial fuel-cladding gap of similar to 300 m if PCMI is to be avoided. The liquid-metal bond permits operation of the fuel at current LWR linear-heat-generation rates without exceeding any design constraint. The behavior of hydrogen in the fuel is the source of phenomena during operation that are absent in oxide fuels. Because of the large heat of transport (thermal diffusivity) of H in ZrHx, redistribution of hydrogen in the temperature gradient in the fuel pellet changes the initial H/Zr ratio of 1.6 to similar to 1.45 at the center and similar to 1.70 at the periphery. Because the density of the hydride decreases with increasing H/Zr ratio, the result of H redistribution is to subject the interior of the pellet to a tensile stress while the outside of the pellet is placed in compression. The resulting stress at the pellet periphery is sufficient to overcome the tensile stress due to thermal expansion in the temperature gradient and to prevent radial cracking that is a characteristic of oxide fuel. Several mechanisms for reduction of the H/Zr ratio during irradiation are identified. The first is transfer of impurity oxygen in the fuel from Zr to rare-earth oxide fission products. The second is the formation of metal hydrides by these same fission products. The third is by loss to the plenum as H-2. The review of the fabrication method for the hydride fuel suggests that its production, even on a large scale, may be significantly higher than the cost of oxide fuel fabrication. (C) 2009 Elsevier B.V. All rights reserved.