Development of Low Cost Glass Melting Furnace for Research Scale

被引：0
|
作者：
Boonin, Kitipun [1 ]
Tuscharoen, Suparat [1 ]
Kaewkhao, Jakrapong [1 ]
机构：
[1] Nakhon Pathom Rajabhat Univ, Ctr Excellence Glass Technol & Mat Sci CEGM, Nakhon Pathom 73000, Thailand
来源：
APPLIED PHYSICS AND MATERIAL APPLICATIONS | 2013年 / 770卷
关键词：
Electrical furnace; Kanthal AF wire; Glass;
D O I：
10.4028/www.scientific.net/AMR.770.241
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
This research is intended to study and construct a two doors electrical furnace. Two line of Kanthal AF wire were used as a heat source furnace. Insulator of furnace was constructed from light brick C-2. The volume of furnace was about 25x30x45 cm(3). Quantity of current flow through heating element was controlled by solid state relay. Temperature of the furnace is measured by thermocouple type K. The result of test performance of the furnace show that the temperature of 1200 degrees C was obtained at 220 volt and current in heating elements of 15 A.
引用
收藏
页码：241 / 244
页数：4
相关论文
共 38 条
  • [11] Effect of an overflow sill on heat and mass transfer in the glass-melting tank of a furnace with horseshoe-shaped flame
    Dzyuzer, V. Ya.
    Shvydkii, V. S.
    GLASS AND CERAMICS, 2006, 63 (7-8) : 215 - 221
  • [12] Effects of SiO2 substitution on the structure and properties of low-melting phosphate glass
    Tabuchi, Heiji
    Kuriyama, Nobuya
    Morimoto, Shigeki
    Journal of the Ceramic Society of Japan. International ed., 1994, 102 (03): : 224 - 227
  • [13] Composite Materials Based on F-4MB Fluoroplastic and Low-Melting Oxyfluoride Glass
    L. N. Ignatieva
    V. A. Mashchenko
    A. Yu. Shaulov
    V. M. Lalayan
    E. V. Stegno
    G. A. Zverev
    I. G. Maslennikova
    Russian Journal of Physical Chemistry A, 2019, 93 : 1652 - 1656
  • [14] Composite Materials Based on F-4MB Fluoroplastic and Low-Melting Oxyfluoride Glass
    Ignatieva, L. N.
    Mashchenko, V. A.
    Shaulov, A. Yu.
    Lalayan, V. M.
    Stegno, E. V.
    Zverev, G. A.
    Maslennikova, I. G.
    RUSSIAN JOURNAL OF PHYSICAL CHEMISTRY A, 2019, 93 (09) : 1652 - 1656
  • [15] Low melting temperature glass nano-particle generation by CO2 laser irradiation
    Hiromatsu K.
    Itoh K.
    Kuroiwa Y.
    Hidai H.
    Tokura H.
    Seimitsu Kogaku Kaishi/Journal of the Japan Society for Precision Engineering, 2011, 77 (08): : 761 - 765
  • [16] Research on oxygen enrichment for municipal solid waste fly ash melting: A pilot-scale study on natural gas and coal as the melting fuel
    Zhang, Yike
    Ma, Zengyi
    Fang, Zhuoting
    Qian, Yuandong
    Huang, Zhiping
    Ye, Yilong
    Yan, Jianhua
    JOURNAL OF ENVIRONMENTAL MANAGEMENT, 2024, 350
  • [17] Development and characterisation of low-cost polymeric composite materials
    El-Tayeb, N. S. M.
    MATERIALS & DESIGN, 2009, 30 (04) : 1151 - 1160
  • [18] A Low-Cost, Non-hazardous Protocol for Surface Texturing of Glass Particles
    Ibekwe, Anelechi
    Tanino, Yukie
    Pokrajac, Dubravka
    TRIBOLOGY LETTERS, 2019, 67 (04)
  • [19] A Low-Cost, Non-hazardous Protocol for Surface Texturing of Glass Particles
    Anelechi Ibekwe
    Yukie Tanino
    Dubravka Pokrajac
    Tribology Letters, 2019, 67
  • [20] Production of sintered glass-ceramic composites from low-cost materials
    Cetin, Suna
    CERAMICS INTERNATIONAL, 2023, 49 (13) : 22386 - 22392
1234