Analysis of the Efficiency of Engine Inlet Air Chilling Unit with Cooling Towers

被引:13
作者
Radchenko, Andrii [1 ]
Stachel, Andrzej [2 ]
Forduy, Serhiy [3 ]
Portnoi, Bohdan [1 ]
Rizun, Oleksandr [1 ]
机构
[1] Admiral Makarov Natl Univ Shipbldg, 9 Heroiv Stalinhradu Ave, UA-54025 Mykolayiv, Ukraine
[2] West Pomeranian Tech Univ, 17 Aleja Piastow, PL-70310 Szczecin, Poland
[3] PepsiCo Inc, 32-2 Moskovska St, UA-01010 Kiev, Ukraine
来源
ADVANCES IN DESIGN, SIMULATION AND MANUFACTURING III: MECHANICAL AND CHEMICAL ENGINEERING, VOL 2 | 2020年
关键词
Turbine; Climate; Thermal load; Chiller; Cooling tower; Fa; GAS; ENHANCEMENT; PLANT;
D O I
10.1007/978-3-030-50491-5_31
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
The processes of cooling air at the inlet of energy installations by exhaust heat conversion chillers with heat removal from them by cooling towers of the circulating cooling system are studied on the example of a gas turbine. Two-stage air cooling is considered using combined type exhaust heat conversion chillers, which utilizes the exhaust gas heat of a gas turbine and which includes absorption lithium-bromide and refrigerant ejector chillers as stages to convert waste heat into cold. The data on current heat loads on exhaust heat conversion chillers and cooling towers in accordance with climatic conditions of operation with the different distribution of heat loads on the cooling towers according to their number was obtained on the base of the results of modeling the operation of the gas turbine cooling complex. It was shown the possibility to increase the fuel saving due to turbine inlet air cooling through decreasing the number of cooling towers and electricity consumption for driving the fans of cooling towers.
引用
收藏
页码:322 / 331
页数:10
相关论文
共 50 条
  • [1] Rational Thermal Loading the Engine Inlet Air Chilling Complex with Cooling Towers
    Radchenko, Mykola
    Portnoi, Bohdan
    Kantor, Serhiy
    Forduy, Serhiy
    Konovalov, Dmytro
    ADVANCED MANUFACTURING PROCESSES II, 2021, : 724 - 733
  • [2] Exergetic and Exergoeconomic Analysis and Optimization of Gas Turbine Inlet Air Cooling Systems with Absorption or Compression Chilling
    Abedi, Mohammad Reza
    Salehi, Gholam Reza
    Azad, Masoud Torabi
    Manesh, Mohammad Hasan Khoshgoftar
    Fallahsohi, Hossein
    INTERNATIONAL JOURNAL OF THERMODYNAMICS, 2021, 24 (02) : 93 - 107
  • [3] ON THE EFFECT OF WATER EVAPORATION ON COOLING EFFICIENCY IN COOLING TOWERS
    Shevelev, Sergey A.
    Zyablova, Natalia N.
    BULLETIN OF THE TOMSK POLYTECHNIC UNIVERSITY-GEO ASSETS ENGINEERING, 2019, 330 (03): : 217 - 224
  • [4] Improving the efficiency of natural draft cooling towers
    Smrekar, J
    Oman, J
    Sirok, B
    ENERGY CONVERSION AND MANAGEMENT, 2006, 47 (9-10) : 1086 - 1100
  • [5] Rational Designing of Gas Turbine Inlet Air Cooling System
    Radchenko, Andrii
    Bohdal, Lukasz
    Zongming, Yang
    Portnoi, Bohdan
    Tkachenko, Veniamin
    ADVANCED MANUFACTURING PROCESSES (INTERPARTNER-2019), 2020, : 591 - 599
  • [6] Prediction of moist air wet processes in cooling coils and cooling towers
    Wang, JF
    Hihara, E
    JOURNAL OF ENHANCED HEAT TRANSFER, 2004, 11 (03) : 217 - 230
  • [7] Increasing the Efficiency of Gas Turbine Inlet Air Cooling in Actual Climatic Conditions of Kazakhstan and Ukraine
    Radchenko, A.
    Radchenko, N.
    Tsoy, A.
    Portnoi, B.
    Kantor, S.
    OIL AND GAS ENGINEERING (OGE-2020), 2020, 2285
  • [8] THERMODYNAMIC ANALYSIS OF GAS TURBINE PERFORMANCE WITH DIFFERENT INLET AIR COOLING TECHNIQUES
    Pereira dos Santos, Ana Paula
    de Andrade, Claudia Regina
    PROCEEDINGS OF THE ASME TURBO EXPO 2012, VOL 3, 2012, : 79 - 89
  • [9] Analysis of Combined Effects of Air Transpiration Cooling and Evaporative Inlet Air Cooling on the Performance Parameters of a Simple Gas Turbine Cycle
    Mohapatra, Alok Ku
    Sanjay
    JOURNAL OF ENERGY ENGINEERING, 2015, 141 (03)
  • [10] Thermohydraulic Efficiency of the Process of Cooling of Water in Miniature Cooling Towers with Regular Packing
    Lapteva, E. A.
    Stolyarova, E. Yu.
    Laptev, A. G.
    CHEMICAL AND PETROLEUM ENGINEERING, 2018, 54 (3-4) : 161 - 164