Fatigue crack propagation in austenitic stainless steel weldments

The fatigue crack propagation rate (FCPR) in 316L austenitic stainless steel (ASS) and its weldments was investigated, at two loading amplitudes, 7 and 8.5 kN, under tension-tension mode. Two welding techniques, submerged arc welding (SAW) and manual arc welding (MAW), have been used. Magnetic delta-ferrite, depending upon Ni and Cr content in the metal, in the weld zone upon solidification was considered. The ferrite number (FN) of delta-ferrite formed in the SAW zone was much higher (maximum 9.6) compared to the corresponding value (maximum 0.75) in the MAW zone. A fatigue starter notch was positioned at different positions and directions with respect to the weld zone, in addition to the heat-affected zone (HAZ). Regions of high and low FCPRs as the fatigue crack propagated through and across the weld zone have been noticed. This is related to the direction of the tensile residual stresses present in weld zone, resulting from solidification of the weld metal. The FCPR was higher along through the HAZ and weld zone because of the microstructural change and direction and distribution of tensile residual stresses. The FCPR was much lower when crack propagated perpendicular to the weld zone, particularly in the case of SAW in which higher delta-ferrite volume fraction was noticed. A lower FCPR found across the weld zone, in both SAW and MAW, was accompanied by rubbed areas in their fractures.