Study of the Joining of Polycarbonate Panels in Butt Joint Configuration Through Friction Stir Welding

被引：1

作者：

Astarita, Antonello ^{[1
]}

Boccarusso, Luca ^{[1
]}

Carrino, Luigi ^{[1
]}

Durante, Massimo ^{[1
]}

Minutolo, Fabrizio Memola Capece ^{[1
]}

Squillace, Antonino ^{[1
]}

机构：

[1] Univ Naples Federico II, Dept Chem Mat & Prod Engn, Ple Tecchio 80, I-80125 Naples, Italy

来源：

PROCEEDINGS OF 21ST INTERNATIONAL ESAFORM CONFERENCE ON MATERIAL FORMING (ESAFORM 2018) | 2018年 / 1960卷

关键词：

PROCESS PARAMETERS; OPTIMIZATION; TOOL; FSW;

D O I：

10.1063/1.5034942

中图分类号：

O59 [应用物理学];

学科分类号：

摘要：

Polycarbonate sheets, 3 mm thick, were successfully friction stir welded in butt joint configuration. Aiming to study the feasibility of the process and the influence of the process parameters joints under different processing conditions, obtained by varying the tool rotational speed and the tool travel speed, were realized. Tensile tests were carried out to characterize the joints. Moreover the forces arising during the process were recorded and carefully studied. The experimental outcomes proved the feasibility of the process when the process parameters are properly set, joints retaining more than 70% of the UTS of the base material were produced. The trend of the forces was described and explained, the influence of the process parameters was also introduced.

引用

页数：6

共 11 条

[1] Effects of double passes of the tool on friction stir welding of polyethylene [J].