High-throughput drilling of titanium alloys

Experiments of high-throughput drilling of Ti-6Al-4V at 183 m/min cutting speed and 156 mm(3)/s material removal rate (MRR) using a 4 mm diameter WC-Co spiral point drill were conducted. The tool material and geometry and drilling process parameters, including cutting speed, feed, and fluid supply, were studied to evaluate the effect on drill life, thrust force, torque, energy, and burr formation. The tool wear mechanism, hole surface roughness, and chip light emission and morphology for high-throughput drilling were investigated. Supplying the cutting fluid via through-the-drill holes has proven to be a critical factor for drill life, which can be increased by 10 times compared to that of dry drilling at 183 m/min cutting speed and 0.051 mm/rev feed. Under the same MRR of 156 mm 3/S with a doubled feed of 0.102 mm/rev (91 m/min cutting speed), over 200 holes can be drilled. The balance of cutting speed and feed is essential to achieve long drill life and good hole surface roughness. This study demonstrates that, using proper drilling process parameters, spiral point drill geometry, and fine-grained WC-Co tool material, the high-throughput drilling of Ti alloy is technically feasible. (C) 2006 Elsevier Ltd. All rights reserved.