Grain refinement and orientation of AZ31B magnesium alloy in hot flow forming under different thickness reductions

An analysis of the hot flow forming of Mg-3.0Al-1.0Zn-0.3Mn (AZ31B) alloy was conducted by experiments and numerical simulations. The effects of different thickness reductions on the microstructure and mechanical properties were investigated at a temperature of 693 K, a spindle speed of 800 rev/min and a feed ratio of 0.1 mm/rev. Thickness reductions have great influence on the uniformity of microstructure along the radial direction (RD) and the grain sizes become refined and uniform when the thickness reduction reaches 45%. The c-axes of most grains are approximately parallel to the RD, with a slight inclination towards the axial direction (AD). The best mechanical properties with UTS of 280 MPa and YS of 175 MPa near the outer surface while 266 MPa and 153 MPa near the inner surface have been achieved due to grain refinement and texture. Moreover, the material flow behavior and stress/strain distributions for single-pass reductions were studied using the ABAQUS/Explicit software. The calculated results indicate that the materials mainly suffer from triaxial compressive stresses and undergo compressive plastic strain in RD and tensile strains in other directions. The higher stress and strain rate near the outer surface lead to more refined grains than that of other regions along the RD, whereas the orientation of the maximum principal compressive stress leads to a discrepancy of the grain orientations in RD. (C) 2017 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.