共 52 条
Comparison of Ligament Isometry and Patellofemoral Contact Pressures for Medial Patellofemoral Ligament Reconstruction Techniques in Skeletally Immature Patients
被引:20
作者:
Black, Sheena R.
[1
,2
]
Meyers, Kathleen N.
[1
]
Nguyen, Joseph T.
[1
]
Green, Daniel W.
[1
]
Brady, Jacqueline M.
[1
,3
]
Maher, Suzanne A.
[1
]
Stein, Beth E. Shubin
[1
]
机构:
[1] Hosp Special Surg, 535 E 70th St, New York, NY 10021 USA
[2] Baylor Univ, Med Ctr, Dallas, TX USA
[3] Oregon Hlth & Sci Univ, Portland, OR 97201 USA
关键词:
knee;
skeletally immature;
patellar instability;
medial patellofemoral ligament reconstruction;
MPFL;
contact pressure;
D O I:
10.1177/0363546520966609
中图分类号:
R826.8 [整形外科学];
R782.2 [口腔颌面部整形外科学];
R726.2 [小儿整形外科学];
R62 [整形外科学(修复外科学)];
学科分类号:
摘要:
Background: Adult medial patellofemoral ligament (MPFL) reconstruction techniques are not appropriate for the skeletally immature patient given the proximity of the distal femoral physis. Biomechanical consequences of reconstructions aimed at avoiding the physis have not been adequately studied. Purpose: To quantify the biomechanical effects of MPFL reconstruction techniques intended for skeletally immature patients. Study Design: Controlled laboratory study Methods: Four MPFL reconstruction techniques were evaluated using a computationally augmented cadaveric model: (1) Schoettle point: adult-type reconstruction; (2) epiphyseal: socket distal to the femoral physis; (3) adductor sling: graft wrapped around the adductor tendon; (4) adductor transfer: adductor tendon transferred to patella. A custom testing frame was used to cycle 8 knees for each technique from 10 degrees to 110 degrees of flexion. Patellofemoral kinematics were recorded using a motion camera system, contact stresses were recorded using Tekscan pressure sensors, and MPFL length was computed using an inverse kinematics computational model. Change in MPFL length, patellar facet forces, and patellar kinematics were compared using generalized estimating equation modeling. Results: Schoettle point reconstruction was the most isometric, demonstrating isometry from 10 degrees to 100 degrees. The epiphyseal technique was isometric until 60 degrees, after which the graft loosened with increasing flexion. The adductor sling and adductor transfer techniques were significantly more anisometric from 40 degrees to 110 degrees. Both grafts tightened with knee flexion and resulted in significantly more lateral patellar tilt versus the intact state in early flexion and significantly higher contact forces on the medial facet versus the epiphyseal technique in late flexion. Conclusion: In this cadaveric simulation, the epiphyseal technique allowed for a more isometric ligament until midflexion, when the patella engaged within the trochlear groove. The adductor sling and adductor transfer grafts became tighter in flexion, resulting in potential loss of motion, pain, graft stretching, and failure. Marginal between-condition differences in patellofemoral contact mechanics and patellar kinematics were observed in late flexion.
引用
收藏
页码:3557 / 3565
页数:9
相关论文