Electrochemical Impedance Studies on the Corrosion of Cu-35Ni-10Al Alloy in a Molten (0.62Li, 0.38K)2CO3 Environment

被引：3

作者：

Ren, Yanjie ^{[1
,2
]}

Peng, Yucheng ^{[1
,2
]}

Chen, Jian ^{[1
,2
]}

Qiu, Wei ^{[1
,2
]}

Li, Wei ^{[1
,2
]}

Li, Cong ^{[1
,2
]}

Niu, Yan ^{[1
,2
]}

机构：

[1] Changsha Univ Sci & Technol, Sch Energy & Power Engn, Changsha 410114, Hunan, Peoples R China

[2] Changsha Univ Sci & Technol, Key Lab Energy Efficiency & Clean Utilizat, Educ Dept Hunan Prov, Changsha 410114, Hunan, Peoples R China

来源：

INTERNATIONAL JOURNAL OF ELECTROCHEMICAL SCIENCE | 2019年 / 14卷 / 07期

基金：

美国国家科学基金会;

关键词：

Cu-35Ni-10Al alloy; Molten carbonate fuel cell; Anode; Corrosion; Electrochemical impedance spectroscopy; CARBONATE FUEL-CELL; ANODE ELECTRODE; OXIDATION; CREEP; SALT;

D O I：

10.20964/2019.07.49

中图分类号：

O646 [电化学、电解、磁化学];

学科分类号：

081704 ;

摘要：

Cu alloy is an anode material that can act as an alternative to Ni alloy in molten carbonate fuel cells (MCFCs) because of its thermodynamic stability in the anode gas atmosphere and its lower cost. To evaluate its potential application as an anode material for MCFCs, the high-temperature corrosion behaviour of cast Cu-35Ni-10Al alloy was studied in molten (0.62Li, 0.38K)(2)CO3 at 650 degrees C in air by electrochemical impedance spectroscopy. An equivalent circuit is proposed to fit the impedance spectroscopy results. The values of R-t decreased with the immersion time, suggesting an enhanced corrosion rate. A porous and layered scale formed on the alloy after immersion for 48 h in the melt. Internal oxidation was observed in the Cu-rich zone of the alloy.

引用

页码：6147 / 6153

页数：7

共 18 条

[1] Oxidation of a quaternary two-phase Cu-40Ni-17.5Cr-2.5Al alloy at 973-1073 K in 101 kPa O2 [J].

Cao, Zhongqiu ;

Shen, Ying ;

Li, Fengchun ;

Yu, Long .

JOURNAL OF ALLOYS AND COMPOUNDS, 2009, 480 (02) :449-453

[2] Electrochemical Impedance Spectra for the Corrosion of Porous Cu-35mass%Ni-(5,10)mass%Cr Alloys in Molten (0.62Li,0.38K)2CO3 at 650 °C in Air [J].

Chen, Jian ;

Huang, Zihan ;

Ren, Yanjie ;

Li, Wei ;

Qiu, Wei ;

Chen, Jianlin ;

He, Jianjun .

HIGH TEMPERATURE MATERIALS AND PROCESSES, 2013, 32 (06) :581-586

[3] Effect of alloying elements on the copper-base anode for molten carbonate fuel cells [J].

Hwang, ER ;

Park, JW ;

Kim, YD ;

Kim, SJ ;

Kang, SG .

JOURNAL OF POWER SOURCES, 1997, 69 (1-2) :55-60

[4] A study of a corrosion-resistant coating for a separator for a molten carbonate fuel cell [J].

Hwang, ER ;

Kang, SG .

JOURNAL OF POWER SOURCES, 1998, 76 (01) :48-53

[5] Investigation on compressive behavior of Cu-35Ni-15Al alloy at high temperatures [J].

Li, Cong ;

Chen, Jian ;

Li, Wei ;

Hu, Yongle ;

Ren, Yanjie ;

Qiu, Wei ;

He, Jianjun ;

Chen, Jianlin .

MATERIALS SCIENCE-POLAND, 2014, 32 (03) :341-349

[6]

Li W., 2015, CHIN J MECH ENG, V2, P58

[7] Electrochemical impedance spectroscopy (EIS) studies of the corrosion of pure Fe and Cr at 600○C under solid NaCl deposit in water vapor [J].

Liu, Li ;

Li, Ying ;

Zeng, Chaoliu ;

Wang, Fuhui .

ELECTROCHIMICA ACTA, 2006, 51 (22) :4736-4743

[8] Electrochemical impedance studies of the initial-stage corrosion of 310S stainless steel beneath thin film of molten (0.62Li, 0.38K)2CO3 at 650 °C [J].

Ni, C. S. ;

Lu, L. Y. ;

Zeng, C. L. ;

Niu, Y. .

CORROSION SCIENCE, 2011, 53 (03) :1018-1024

[9]

Numata H., 1991, ZAIRYO TO KANKYO, V40, P110

[10] Synthesis and Characterization of Molten Carbonate Fuel Cell Anode Materials [J].

Ozkan, G. ;

Iyidir, U. C. .

ENERGY SOURCES PART A-RECOVERY UTILIZATION AND ENVIRONMENTAL EFFECTS, 2015, 37 (22) :2487-2495

← 1 2 →