Evaluation of proton conducting BCY10-based anode supported cells by co-pressing method: Up-scaling, performances and durability

被引：16
作者：
Dailly, J. [1 ]
Marrony, M. [1 ]
Taillades, G. [2 ]
Taillades-Jacquin, M. [2 ]
Grimaud, A. [3 ]
Mauvy, F. [3 ]
Louradour, E. [4 ]
Salmi, J. [5 ]
机构：
[1] EDF EIFER, D-76131 Karlsruhe, Germany
[2] Univ Montpellier, CNRS, AIME, F-33608 Montpellier, France
[3] Univ Bordeaux, ICMCB, CNRS, F-33608 Pessac, France
[4] CTI, F-30340 Salindres, France
[5] Marion Technol, F-09340 Verniolle, France
来源：
JOURNAL OF POWER SOURCES | 2014年 / 255卷
关键词：
Praseodymium nickelate; Yttrium-doped barium cerate; Co-pressing; Screen-printing; Up-scaling; Proton ceramic fuel cell; FUEL-CELLS; ELECTROLYTE; CATHODE; WATER; PEROVSKITE; OXIDES;
D O I：
10.1016/j.jpowsour.2013.12.082
中图分类号：
O64 [物理化学（理论化学）、化学物理学];
学科分类号：
070304 ; 081704 ;
摘要：
One of the main target of the French ANR CONDOR (2009-2011) project coordinated by EDF-EIFER was the elaboration of proton conducting BaCe0.9Y0.1O3-delta-based cells using processes suitable at industrial level. Thus, commercial powders produced at kilogram scale (anode, electrolyte and cathode) have been analysed and used. Then, elaboration of protonic ceramic half-cells by co-pressing method from 25 mm to 80 mm in diameter has been assessed in order to establish the suitability of this shaping method regarding industrial requirements. According to results, the co-pressing method is relevant for the elaboration of cells up to 40 mm in diameter (laboratory experiment). A sintering step was carried out to densify the electrolyte layer to get a gas-tight membrane. Nickelate-based cathodes were screen-printed and electrochemical performances of the final assembly have been measured. Electrical power up to 180 mW cm(-2) at 600 degrees C has been obtained on both 25 and 40 mm cells. (C) 2013 Elsevier B.V. All rights reserved.
引用
收藏
页码：302 / 307
页数：6
相关论文
共 37 条
  • [1] Protonic and native conduction in Sr-substituted LaPO4 studied by thermoelectric power measurements
    Amezawa, K
    Kjelstrup, S
    Norby, T
    Ito, Y
    [J]. JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 1998, 145 (10) : 3313 - 3319
  • [2] Enhanced sintering of yttrium-doped barium zirconate by addition of ZnO
    Babilo, P
    Haile, SM
    [J]. JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2005, 88 (09) : 2362 - 2368
  • [3] The high temperature proton conductor Ba3Ca1.18Nb1.82O9-δ.: I.: Electrical conductivity
    Bohn, HG
    Schober, T
    Mono, T
    Schilling, W
    [J]. SOLID STATE IONICS, 1999, 117 (3-4) : 219 - 228
  • [4] Electrochemical properties of perovskite and A2MO4-type oxides used as cathodes in protonic ceramic half cells
    Dailly, J.
    Mauvy, F.
    Marrony, M.
    Pouchard, M.
    Grenier, Jean-Claude
    [J]. JOURNAL OF SOLID STATE ELECTROCHEMISTRY, 2011, 15 (02) : 245 - 251
  • [5] Perovskite and A2MO4-type oxides as new cathode materials for protonic solid oxide fuel cells
    Dailly, J.
    Fourcade, S.
    Largeteau, A.
    Mauvy, F.
    Grenier, J. C.
    Marrony, M.
    [J]. ELECTROCHIMICA ACTA, 2010, 55 (20) : 5847 - 5853
  • [6] Dailly J., 2008, THESIS U BORDEAUX 1
  • [7] Synthesis and characterization of Ni-cermet/proton conducting thin film electrolyte symmetrical assemblies
    Essoumhi, A.
    Taillades, G.
    Taillades-Jacquin, M.
    Jones, D. J.
    Roziere, J.
    [J]. SOLID STATE IONICS, 2008, 179 (38) : 2155 - 2159
  • [8] Tailoring the chemical stability of Ba(Ce0.8-xZrx)Y0.2O3-δ protonic conductors for Intermediate Temperature Solid Oxide Fuel Cells (IT-SOFCs)
    Fabbri, Emiliana
    D'Epifanio, Alessandra
    Di Bartolomeo, Elisabetta
    Licoccia, Silvia
    Traversa, Enrico
    [J]. SOLID STATE IONICS, 2008, 179 (15-16) : 558 - 564
  • [9] OXIDE-ION CONDUCTION IN BA2IN2O5 AND BA3IN 2CEO8, BA3IN2HFO8, OR BA3IN2ZRO8
    GOODENOUGH, JB
    RUIZDIAZ, JE
    ZHEN, YS
    [J]. SOLID STATE IONICS, 1990, 44 (1-2) : 21 - 31
  • [10] Grimaud A., 2011, THESIS U BORDEAUX 1
1234