Fiber coating with surfactant solutions

被引:124
作者
Shen, AQ [1 ]
Gleason, B
McKinley, GH
Stone, HA
机构
[1] Harvard Univ, Div Engn & Appl Sci, Cambridge, MA 02138 USA
[2] MIT, Dept Mech Engn, Hatsopoulos Microfluids Lab, Cambridge, MA 02139 USA
关键词
D O I
10.1063/1.1512287
中图分类号
O3 [力学];
学科分类号
08 ; 0801 ;
摘要
When a fiber is withdrawn at low speeds from a pure fluid, the variation in the thickness of the entrained film with imposed fiber velocity is well-predicted by the Landau-Levich-Derjaguin (LLD) equation. However, surfactant additives are known to alter this response. We study the film thickening properties of the protein BSA (bovine serum albumin), the nonionic surfactant Triton X-100, and the anionic surfactant SDS (sodium dodecyl sulfate). For each of these additives, the film thickening factor alpha (the ratio of the measured thickness to the LLD prediction) for a fixed fiber radius varies as a function of the ratio of the surfactant concentration c to the critical micelle concentration (CMC). In the case of BSA, which does not form micelles, the reference value is the concentration at which multilayers form. As a result of Marangoni effects, alpha reaches a maximum as c approaches the CMC from below. However, when the surfactant concentration c exceeds the CMC, the behavior of alpha varies as a consequence of the dynamic surface properties, owing for example to different sorption kinetics of these additives, or possibly surface or bulk rheological effects. For SDS, alpha begins to decrease when c exceeds the CMC and causes the surface to become partially or completely remobilized, which is consistent with the experimental and theoretical results published for studies of slug flows of bubbles and surfactant solutions in a capillary tube and the rise of bubbles in surfactant solutions. However, when the SDS or Triton X-100 surfactant concentration is well above the CMC, we observe that the film thickening parameter alpha increases once again. In the case of SDS we observe a second maximum in the film thickening factor. For all the experiments, transport of monomers to the interface is limited by diffusion and the second maximum in the film thickening factor may be explained as a result of a nonmonotonic change in the stability characteristics of suspended SDS micelles and corresponding changes in the rheology of the solution. (C) 2002 American Institute of Physics.
引用
收藏
页码:4055 / 4068
页数:14
相关论文
共 33 条
[1]  
ADAMSON AW, 1997, PHYSICAL CHEM SURFAC
[2]   Contact line stability and "undercompressive shocks" in driven thin film flow [J].
Bertozzi, AL ;
Münch, A ;
Fanton, X ;
Cazabat, AM .
PHYSICAL REVIEW LETTERS, 1998, 81 (23) :5169-5172
[3]   THE MOTION OF LONG BUBBLES IN TUBES [J].
BRETHERTON, FP .
JOURNAL OF FLUID MECHANICS, 1961, 10 (02) :166-188
[4]   CAPILLARITY-CONTROLLED ENTRAINMENT OF LIQUID BY A THIN CYLINDRICAL FILAMENT MOVING THROUGH AN INTERFACE [J].
CARROLL, BJ ;
LUCASSEN, J .
CHEMICAL ENGINEERING SCIENCE, 1973, 28 (01) :23-30
[5]   ADSORPTION DYNAMICS OF SURFACTANTS AT THE AIR/WATER INTERFACE - A CRITICAL-REVIEW OF MATHEMATICAL-MODELS, DATA, AND MECHANISMS [J].
CHANG, CH ;
FRANSES, EI .
COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 1995, 100 :1-45
[6]   The dynamic adsorption of charged amphiphiles: The evolution of the surface concentration, surface potential, and surface tension [J].
Datwani, SS ;
Stebe, KJ .
JOURNAL OF COLLOID AND INTERFACE SCIENCE, 1999, 219 (02) :282-297
[7]   Fluid coating from a polymer solution [J].
de Ryck, A ;
Quere, D .
LANGMUIR, 1998, 14 (07) :1911-1914
[8]  
Derjaguin B. V., 1943, ACTA PHYSICOCHIM USS, V20, P349
[9]   Inertial coating of a fibre [J].
DeRyck, A ;
Quere, D .
JOURNAL OF FLUID MECHANICS, 1996, 311 :219-237
[10]  
DERYCK A, 1993, CR ACAD SCI II, V317, P891