Microstructural and wear characteristics of HVOF-sprayed nanocrystalline NiAl coating

被引：21
作者：
Enayati, M. H. [1 ]
Karimzadeh, F. [1 ]
Jafari, M. [1 ]
Markazi, A. [1 ]
Tahvilian, A. [1 ]
机构：
[1] Isfahan Univ Technol, Dept Mat Engn, Ctr Excellence Appl Nanotechnol, Esfahan 8415683111, Iran
来源：
WEAR | 2014年 / 309卷 / 1-2期
关键词：
Intermetallics; Sliding wear; Thermal spray coatings; NANOSTRUCTURED COATINGS; INTERMETALLIC COMPOUND; TRIBOLOGICAL BEHAVIOR; AL;
D O I：
10.1016/j.wear.2013.10.015
中图分类号：
TH [机械、仪表工业];
学科分类号：
0802 ;
摘要：
In this research, the microstructure and dry sliding friction and wear behavior of nanocrystalline NiAl coatings were investigated. Toward this purpose, nanocrystalline NiAl powders were initially prepared by mechanical alloying (MA) and deposited on low carbon steel substrate by high velocity oxygen fuel (HVOF) thermal spray process with two sets of spray parameters. The coatings were characterized with respect to their microstructure and phase compositions using scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM) and X-ray diffractometry (XRD). In addition, the friction and wear behavior of coating were tested under three loads of 30, 60 and 90 N. Microstructural observations showed that the as-sprayed coatings include mainly NiAl intermetallic compound with a crystallite size of similar to 20 nm, although there exist some Al2O3 and Ni phases. HVOF spraying at higher fuel/oxygen ratio caused higher amounts of non-NiAl phases and lower hardness and wear resistance. The wear mechanisms and friction behavior of nanocrystalline NiAl coatings were evaluated and discussed in detail. (C) 2013 Elsevier B.V. All rights reserved.
引用
收藏
页码：192 / 199
页数：8
相关论文
共 22 条
[1]   Structure and mechanical properties of NiAl and Ni3Al-based alloys [J].
Czeppe, T ;
Wierzbinski, S .
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES, 2000, 42 (08) :1499-1518
[2]   Mechanisms of oxidation and its role in microstructural evolution of metallic thermal spray coatings - Case study for Ni-Al [J].
Deshpande, S ;
Sampath, S ;
Zhang, H .
SURFACE & COATINGS TECHNOLOGY, 2006, 200 (18-19) :5395-5406
[3]   Synthesis of nanocrystalline NiAl by mechanical alloying [J].
Enayati, M. H. ;
Karimzadeh, F. ;
Anuari, S. Z. .
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2008, 200 (1-3) :312-315
[4]   Nanocrystalline NiAl Coating Prepared by HVOF Thermal Spraying [J].
Enayati, M. H. ;
Karimzadeh, F. ;
Tavoosi, M. ;
Movahedi, B. ;
Tahvilian, A. .
JOURNAL OF THERMAL SPRAY TECHNOLOGY, 2011, 20 (03) :440-446
[5]   Microstructural development in dispersion strengthened NiAl produced by mechanical alloying and secondary recrystallization [J].
Grahle, P ;
Arzt, E .
ACTA MATERIALIA, 1997, 45 (01) :201-211
[6]   The erosion behaviour of NiAl intermetallic coatings produced by high velocity oxy-fuel thermal spraying [J].
Hearley, JA ;
Little, JA ;
Sturgeon, AJ .
WEAR, 1999, 233 :328-333
[7]   The effect of spray parameters on the properties of high velocity oxy-fuel NiAl intermetallic coatings [J].
Hearley, JA ;
Little, JA ;
Sturgeon, AJ .
SURFACE & COATINGS TECHNOLOGY, 2000, 123 (2-3) :210-218
[8]   Wear behaviour of cast and mushy state rolled Al-4.5Cu alloy and in-situ Al4.5Cu-5TiB2 composite [J].
Herbert, Mervin A. ;
Maiti, R. ;
Mitra, R. ;
Chakraborty, M. .
WEAR, 2008, 265 (11-12) :1606-1618
[9]   Preparation and properties of HVOF NiAl nanostructured coatings [J].
Hu, Wangyu ;
Li, Meiheng ;
Fukumoto, Masahiro .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2008, 478 (1-2) :1-8
[10]   Compressive and wear behaviors of bulk nanostructured Al2024 alloy [J].
Jafari, M. ;
Enayati, M. H. ;
Abbasi, M. H. ;
Karimzadeh, F. .
MATERIALS & DESIGN, 2010, 31 (02) :663-669
123