Process integration of a Ca-looping carbon capture process in a cement plant

被引：63

作者：

Ozcan, Dursun Can ^{[1
]}

Ahn, Hyungwoong ^{[1
]}

Brandani, Stefano ^{[1
]}

机构：

[1] Univ Edinburgh, Sch Engn, Inst Mat & Proc, Edinburgh EH9 3JL, Midlothian, Scotland

来源：

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL | 2013年 / 19卷

基金：

英国工程与自然科学研究理事会;

关键词：

Carbon capture; Cement plant; Ca-looping process; CO2; CAPTURE; POWER-PLANTS; TECHNOLOGIES; CALCINATION; EFFICIENCY; REDUCTION; PARTICLES; REMOVAL; BED;

D O I：

10.1016/j.ijggc.2013.10.009

中图分类号：

X [环境科学、安全科学];

学科分类号：

08 ; 0830 ;

摘要：

An analysis of the integration of a Ca-looping process into a cement plant is presented. The capture process, based on selective absorption of CO2 by calcium oxide, has two interconnected reactors where the carbonator captures CO2 from the preheater flue gases and the calciner regenerates the CaCO3 into CaO by oxy-combustion. The study also considers the purge rate of part of the circulating CaO, given the tendency of the material to sinter and reduce its capture capacity. Fresh CaCO3 is added to maintain reactivity in the carbonator, while the purged sorbents are utilised as a cement kiln feed. The detailed carbonator model has been implemented using Matlab and incorporated into Unisim to provide a full flowsheet simulation for an exemplary dry-feed cement plant as a user-defined operation. The effect of molar flowrate ratio of lime make-up to feed CO2 (F-0/FCO2) between two operational limits has been investigated. This process configuration is capable of achieving over 90% CO2 capture with additional fuel consumption of 2.5-3.0 GJ(th)/ton CO2 avoided which depends on the F-0/F-CO2 ratio. It is found that a proper heat recovery system supplementary to the Ca-looping process makes the Ca-looping process more competitive than the traditional low temperature absorption process based on amine solvents. (C) 2013 Elsevier Ltd. All rights reserved.

引用

页码：530 / 540

页数：11

共 50 条

[11] CO2 Capture Technologies for Cement Industry [J].

Bosoaga, Adina ;

Masek, Ondrej ;

Oakey, John E. .

GREENHOUSE GAS CONTROL TECHNOLOGIES 9, 2009, 1 (01) :133-140

[12] Parametric investigation of the calcium looping process for CO2 capture in a 10 kWth dual fluidized bed [J].

Charitos, A. ;

Hawthorne, C. ;

Bidwe, A. R. ;

Sivalingam, S. ;

Schuster, A. ;

Spliethoff, H. ;

Scheffknecht, G. .

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL, 2010, 4 (05) :776-784

[13]

CURRAN GP, 1967, ADV CHEM SER, P141

[14]

CW Group, 2012, GLOB CEM VOL FOR REP

[15] The calcium looping cycle for CO2 capture from power generation, cement manufacture and hydrogen production [J].

Dean, C. C. ;

Blamey, J. ;

Florin, N. H. ;

Al-Jeboori, M. J. ;

Fennell, P. S. .

CHEMICAL ENGINEERING RESEARCH & DESIGN, 2011, 89 (6A) :836-855

[16] Investigation into potential synergy between power generation, cement manufacture and CO2 abatement using the calcium looping cycle [J].

Dean, Charles C. ;

Dugwell, Denis ;

Fennell, Paul S. .

ENERGY & ENVIRONMENTAL SCIENCE, 2011, 4 (06) :2050-2053

[17]

Dieter H., 2012, 21 INT C FLUID BED C, P397

[18] A feasible process for simultaneous removal of CO2, SO2 and NOx in the cement industry by NH3 scrubbing [J].

Dong, Ruifeng ;

Lu, Hongfang ;

Yu, Yunsong ;

Zhang, Zaoxiao .

APPLIED ENERGY, 2012, 97 :185-191

[19]

ECRA, 2009, TECHN REP ECRA CCS P

[20]

ECRA, 2007, TECHN REP CARB CAPT

← 1 2 3 4 5 →