Welding of thin sheet of Al alloy (6082) by using Vario wire DC P-GMAW

This paper describes an investigation on the micro-structure, weld bead geometry, dilution rate and mechanical properties of the butt and overlap weld joints of 1-mm-thick 6082 aluminium alloy sheet. Weld joints were produced with the help of a variant of gas metal arc welding (GMAW) process, i.e. direct current-pulsed GMAW (DC P-GMAW), using a Vario wire. The capability of the new process has been assessed in terms of dilution, weld bead geometry, mechanical properties and porosity. The welding results with this new process showed good process stability in the welding of thin sheets of aluminium, while weld mismatch was found to increase with an increase in heat input. Weld bead geometry parameters such as weld size, throat and weld convexity increases with the increase in heat input. The dilution in case of lap joints (10-25%) was less than that of butt joints (60-80%). The increase in factor I broken vertical bar (summarizing the effect of pulse parameters) increases the form factor and lowers the toe angle. Mechanical properties of the welds are poor as the tensile strength of 6082 alloy welds was around 150 MPa, and the percent elongation was about 1.3%, and it was primarily due to high porosity. Porosity (%) in weld joints was found in the range of 0.33-11.59%. The porosity is a major issue with DC P-GMAW welds.