Inkjet printing and adhesion characterisation of conductive tracks on a commercial printed circuit board material

被引：55

作者：

Sridhar, A. ^{[1
]}

van Dijk, D. J. ^{[1
]}

Akkerman, R. ^{[1
]}

机构：

[1] Univ Twente, Prod Technol Grp, NL-7500 AE Enschede, Netherlands

来源：

THIN SOLID FILMS | 2009年 / 517卷 / 16期

关键词：

Inkjet printing; Nanoparticles; Printed circuit board; Pull-off test; JET; POLYMERS;

D O I：

10.1016/j.tsf.2009.03.133

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Silver nanoparticle-based conductive tracks were inkjet printed using a piezoelectric drop-on-demand inkjet printer on a commercially available electronics grade fibre glass (E-glass) reinforced substrate material, and the experimental results have been summarised. Ink jetting was done on two variants of this substrate material, viz. etched and unetched, to determine the influence of substrate surface topography on adhesion and accuracy of the printed tracks. The pull-off adhesion test method was used to quantify adhesive strength. The dependence of the pull-off test results on local geometry of the test area are illustrated with the aid of scanning electron microscope images and interferometer studies. Based on the outcomes of the experiments, conclusions concerning the suitable surface topography for inkjet printing have been arrived at. (C) 2009 Elsevier B.V. All rights reserved.

引用

页码：4633 / 4637

页数：5

共 15 条

[1]

[Anonymous], 2002, 46242002 ISO

[2] Inkjet printing of polymers: State of the art and future developments [J].