Compound heat transfer enhancement of a dimpled tube with a twisted tape swirl generator

被引：175

作者：

Thianpong, Chinaruk ^{[1
]}

Eiamsa-ard, Petpices ^{[1
]}

Wongcharee, Khwanchit ^{[2
]}

Eiamsa-ard, Smith ^{[3
]}

机构：

[1] King Mongkuts Inst Technol Ladkrabang, Fac Engn, Dept Mech Engn, Bangkok 10520, Thailand

[2] Mahanakorn Univ Technol, Fac Engn, Dept Chem Engn, Bangkok 10530, Thailand

[3] Mahanakorn Univ Technol, Fac Engn, Dept Mech Engn, Bangkok 10530, Thailand

来源：

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER | 2009年 / 36卷 / 07期

关键词：

Compound heat transfer; Friction factor; Dimpled tube; Twisted tape; PRESSURE-DROP; AUGMENTATION; LAMINAR; FLOW;

D O I：

10.1016/j.icheatmasstransfer.2009.03.026

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

Friction and compound heat transfer behaviors in a dimpled tube fitted with a twisted tape swirl generator are investigated experimentally using air as working fluid. The effects of the pitch and twist ratio on the average heat transfer coefficient and the pressure loss are determined in a circular tube with the fully developed flow for the Reynolds number in the range of 12,000 to 44,000. The experiments are performed using two dimpled tubes with different pitch ratios of dimpled surfaces (PR = 0.7 and 1.0) and three twisted tapes with three different twist ratios (y/w = 3, 5, and 7). Experiments using plain tube and dimpled tube acting alone are also carried out for comparison. The experimental results reveal that both heat transfer coefficient and friction factor in the dimpled tube fitted with the twisted tape, are higher than those in the dimple tube acting alone and plain tube. It is also found that the heat transfer coefficient and friction factor in the combined devices increase as the pitch ratio (PR) and twist ratio (y/w) decrease. In addition, an empirical correlation based on the experimental results of the present study is sufficiently accurate for prediction the heat transfer (Nu) and friction factor (f) behaviors. (C) 2009 Elsevier Ltd. All rights reserved.

引用

页码：698 / 704

页数：7

共 14 条

[1] Pressure drop and heat transfer comparison for both microfin tube and twisted-tape inserts in laminar flow [J].

Al-Fahed, S ;

Chamra, LM ;

Chakroun, W .

EXPERIMENTAL THERMAL AND FLUID SCIENCE, 1998, 18 (04) :323-333

[2] ExHFT for fourth generation heat transfer technology [J].

Bergles, AE .

EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2002, 26 (2-4) :335-344

[3] Heat transfer enhancement in dimpled tubes [J].

Chen, J ;

Müller-Steinhagen, H ;

Duffy, GG .

APPLIED THERMAL ENGINEERING, 2001, 21 (05) :535-547

[4] Turbulent flow heat transfer and pressure loss in a double pipe heat exchanger with louvered strip inserts [J].

Eiamsa-ard, Smith ;

Pethkool, Somsak ;

Thianpong, Chinaruk ;

Promvonge, Pongjet .

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2008, 35 (02) :120-129

[5]

Incropera F.P., 2018, Fundamentals of Heat and Mass Transfer, V6

[6] Augmentation of convective heat transfer inside tubes with three-dimensional internal extended surfaces and twisted-tape inserts [J].

Liao, Q ;

Xin, MD .

CHEMICAL ENGINEERING JOURNAL, 2000, 78 (2-3) :95-105

[7] The mechanical properties of intermetallic Ni50-xTi50Alx alloys (x=6,7,8,9) [J].

Meng, L. J. ;

Li, Y. ;

Zhao, X. Q. ;

Xu, J. ;

Xu, H. B. .

INTERMETALLICS, 2007, 15 (5-6) :814-818

[8] Thermohydraulics of laminar flow through rectangular and square ducts with transverse ribs and twisted tapes [J].

Pramanik, Debashis ;

Saha, Sujoy K. .

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME, 2006, 128 (10) :1070-1080

[9] Thermal augmentation in circular tube with twisted tape and wire coil turbulators [J].

Promonge, Pongjet .

ENERGY CONVERSION AND MANAGEMENT, 2008, 49 (11) :2949-2955

[10] Heat transfer behaviors in a tube with combined conical-ring and twisted-tape insert [J].

Promvonge, P. ;

Eiamsa-ard, S. .

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2007, 34 (07) :849-859

← 1 2 →