Performance and Economic Comparative Study of Interlocking Block and Clay Brick Buildings

被引:0
|
作者
Chaimoon, Nida [1 ]
Lertsatitthanakorn, Charoenporn [2 ]
Chaimoon, Krit [3 ]
机构
[1] Mahsarakham Univ, Fac Engn, Field Environm Engn, Ampher Kantarawichai, Mahasarakham, Thailand
[2] Mahsarakham Univ, Fac Engn, Field Mech Engn, Ampher Kantarawichai, Mahasarakham, Thailand
[3] Mahsarakham Univ, Fac Engn, Field Civil Engn, Ampher Kantarawichai, Mahasarakham, Thailand
来源
PROGRESS IN INDUSTRIAL AND CIVIL ENGINEERING II, PTS 1-4 | 2013年 / 405-408卷
关键词
conduction heat transfer; thermal conductivity; payback period;
D O I
10.4028/www.scientific.net/AMM.405-408.2893
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
This paper presents the results of an inquiry into the comparative thermal performance and economic viability of interlocking block and clay brick. To this end, two test rooms of 2.4 m width, 2.4 m length and 2 m height were built. The first room was constructed using interlocking block wall whereas the second room used commercial clay brick wall. Data recorded included room temperature, inside and outside surfaces temperatures of all walls, and solar intensity. The experimental results showed that heat conducted better through the interlocking block than through the clay brick. This was not surprising because the thermal conductivity of the interlocking block is 234% higher than the clay brick. However, the cost of interlocking block wall was lower than the clay brick wall by 34.5%. An economic analysis indicates that the payback period of the clay brick in tandem with a 1 ton, split-type air-conditioner depends on the indoor set-point temperature. The payback period extends over a considerable time, and as such, the interlocking block represents the most cost effective alternative for wall construction.
引用
收藏
页码:2893 / +
页数:2
相关论文
共 40 条
  • [31] Preparation and performance of alumina/epoxy-siloxane composites: A comparative study on thermal- and photo-curing process
    Kim, Chan Soo
    Jang, Junho
    Im, Hyeon-Gyun
    Yoon, Seogyoung
    Kang, Dong Jun
    HELIYON, 2024, 10 (05)
  • [32] Performance and feasibility study of a heat pump with modified solar-air source evaporator: Techno-economic analysis for water heating
    Chinnasamy, Subramaniyan
    Prakash, K. B.
    Divyabharathi, R.
    Kalidasan, B.
    Rajamony, Reji Kumar
    Pandey, A. K.
    Fouad, Yasser
    Soudagar, Manzoore Elahi M.
    INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2024, 157
  • [33] Thermal performance enhancement of palmitic-stearic acid by adding graphene nanoplatelets and expanded graphite for thermal energy storage: A comparative study
    Yuan, Yanping
    Zhang, Nan
    Li, Tianyu
    Cao, Xiaoling
    Long, Weiyue
    ENERGY, 2016, 97 : 488 - 497
  • [34] A novel comparative investigation of the effect of the number of neurons on the predictive performance of the artificial neural network: An experimental study on the thermal conductivity of ZrO2 nanofluid
    Colak, Andac Batur
    INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2021, 45 (13) : 18944 - 18956
  • [35] Study of Rheological Behavior, Economic Performance and Development of a Model for MWCNT-ZnO (30:70)/10W40 Hybrid Nanofluid Using Response Surface Methodology
    Esfe, Mohammad Hemmat
    Motallebi, Sayyid Majid
    Esfandeh, Saeed
    Toghraie, Davood
    KOREAN JOURNAL OF CHEMICAL ENGINEERING, 2024, 41 (03) : 909 - 921
  • [36] Economic evaluation and annual performance analysis of a novel series-coupled PV/T and solar TC with solar direct expansion heat pump system: An experimental and numerical study
    Abbas, Sajid
    Zhou, Jinzhi
    Hassan, Atazaz
    Yuan, Yanping
    Yousuf, Saima
    Sun, Yafen
    Zeng, Chao
    RENEWABLE ENERGY, 2023, 204 : 400 - 420
  • [37] Comparative analysis of heat transfer performance in film boiling on a superheated vertical cylinder: A detailed CFD study of water-based Al 2 O 3 and Cu nanofluids
    Yahyaee, A.
    POWDER TECHNOLOGY, 2024, 444
  • [38] Comparative rheological study on hybrid nanofluids with the same structure of MWCNT (50%)-ZnO(50%)/SAE XWX to select the best performance of nano-lubricants using response surface modeling
    Hemmat Esfe, Mohammad
    Alidoust, Soheyl
    Asdeshiri, Erfan Mohammadnejad
    Toghraie, Davood
    COLLOIDS AND SURFACES A-PHYSICOCHEMICAL AND ENGINEERING ASPECTS, 2022, 641
  • [39] A comparative study on entropy and thermal performance of Cu/CuO/Fe3O4-based engine oil Carreau nanofluids in PTSCs: a theoretical model for solar-powered aircraft applications
    Raafat, Philopatir B.
    AbuGhanem, Muhammad
    Ibrahim, Fayez N.
    Hendy, Ahmed S.
    Zaky, Mahmoud A.
    JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2024, 149 (08) : 3677 - 3697
  • [40] Comparative study on heat transfer performance of ?Al2O3 - C2H6O2 and ?Al2O3 - H2O nanofluids via Prabhakar fractional derivative model for MHD channel flows
    Asifa
    Anwar, Talha
    Kumam, Poom
    Muhammad, Shah
    CASE STUDIES IN THERMAL ENGINEERING, 2022, 38