Imaging P- and S-wave velocity structures in hydrate bearing sediments along an OBS profile across the Yuan-An Ridge, off southwest Taiwan

In order to improve our understanding of the marine slope instability of hydratebearing sediments in the offshore southwestern Taiwan, P-and S-waves seismic data generated by P-S conversion on reflection from airgun shots recorded from a multicomponent Ocean Bottom Seismometer (OBS) survey were used to construct twodimensional velocity model. The investigated profile lies above a structural high of the Yuan-An ridge, proposed as a high priority drilling site for gas hydrate investigations off southwest Taiwan. The locations of the OBSs were determined with high accuracy by an inversion based on the shot traveltimes. Traveltime inversion and forward modeling of seismic data result in general trends P-and S-wave velocities of sediments. Generally, P-and S-wave velocities are high beneath topographic ridges which might represent a series of thrust-cored anticlines develop in the accretionary wedge. P-wave velocities of the sea floor are about similar to 1.58 km s(-1), increasing to the bottom simulating reflectors (BSR), reaching values of about similar to 2 km s(-1). Below it, a low velocity layer (1.62 -1.74 km s(-1)) is observed, which indicates the presence free gas in the sedimentary layer. S-wave velocities of the sediments over the entire section range from 0.3 to similar to 0.6 km s(-1). Significant lateral velocity variations were found beneath the eastern flank of the Yuan-An ridge, probably represents thrust faults that extend from seafloor to hydrate-bearing layer. We suggest that the BSR has been disturbed by the thrust faults and further rupture of the fault could potentially trigger failures in the study area.