Growth of CNx/BN:C multilayer films by magnetron sputtering

被引:21
作者
Johansson, MP [1 ]
Hellgren, N [1 ]
Berlind, T [1 ]
Broitman, E [1 ]
Hultman, L [1 ]
Sundgren, JE [1 ]
机构
[1] Linkoping Univ, Dept Phys, Thin Films Phys Div, S-58183 Linkoping, Sweden
关键词
sputtering; multilayers; carbon nitride; boron nitride; transmission electron microscopy; nanoindentation;
D O I
10.1016/S0040-6090(99)00950-5
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Symmetric CNx/BN:C multilayer thin films, with nominal compositional modulation periods of Lambda = 2.5, 5, and 9 nm were deposited by unbalanced dual cathode magnetron sputtering from C (graphite) and B4C targets in an Ar/N-2 (60/40) discharge. The multilayers and singlelayer of the constituent CNx and BN:C compounds were grown to a total thickness of 0.5 mu m onto Si(001) substrates held at 225 degrees C and a negative floating potential of similar to 30 V (E-i approximate to 24 eV). Layer characterizations were pet-formed by TEM, X-ray reflectivity? RES, and nanoindentation measurements. Results show that CN0.33 and BN:C (35, 50, and 15 at.% of B, N, and C, respectively) layers were prepared at the above conditions. It is suggested that all films exhibit a three-dimensional interlocked structure with a cylindrical texture in the film growth direction. The structure was continuous over relatively well defined and smooth CNx/BN:C interfaces. All coatings exhibit extreme elasticity with elastic recoveries as high as 85-90% (10 mN maximum load) attributed to the observed structure. However, the multilayers were stiffer and more elastic compared to that of the single-layers and thus shows promise for improved protective properties. (C) 2000 Elsevier Science S.A All rights reserved.
引用
收藏
页码:17 / 23
页数:7
相关论文
共 21 条
  • [1] AGARVALL BK, 1979, XRAY SPECTROSCOPY IN
  • [2] BARNETT S, 1993, PHYSICS THIN FILMS
  • [3] MECHANICAL-PROPERTIES OF AMORPHOUS AND POLYCRYSTALLINE MULTILAYER SYSTEMS
    BARZEN, I
    EDINGER, M
    SCHERER, J
    ULRICH, S
    JUNG, K
    EHRHARDT, H
    [J]. SURFACE & COATINGS TECHNOLOGY, 1993, 60 (1-3) : 454 - 457
  • [4] FORMATION OF C-N THIN-FILMS BY ION-BEAM DEPOSITION
    BOYD, KJ
    MARTON, D
    TODOROV, SS
    ALBAYATI, AH
    KULIK, J
    ZUHR, RA
    RABALAIS, JW
    [J]. JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A-VACUUM SURFACES AND FILMS, 1995, 13 (04): : 2110 - 2122
  • [5] Tribological behavior of amorphous carbon nitride overcoats for magnetic thin-film rigid disks
    Cutiongco, EC
    Li, D
    Chung, YW
    Bhatia, CS
    [J]. JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME, 1996, 118 (03): : 543 - 548
  • [6] MECHANICAL-PROPERTIES OF VACUUM-DEPOSITED METAL-FILMS .3. LAYERED CU AND NI SINGLE-CRYSTAL COMPOSITES
    HENNING, CAO
    BOSWELL, FW
    CORBETT, JM
    [J]. ACTA METALLURGICA, 1975, 23 (02): : 193 - 197
  • [7] Low-temperature deposition of cubic BN:C films by unbalanced direct current magnetron sputtering of a B4C target
    Johansson, MP
    Ivanov, I
    Hultman, L
    Munger, EP
    Schutze, A
    [J]. JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A-VACUUM SURFACES AND FILMS, 1996, 14 (06): : 3100 - 3107
  • [8] HREM and nanoindentation studies of BN:C films deposited by reactive sputtering from a B4C target
    Johansson, MP
    Sjöström, H
    Hultman, L
    [J]. VACUUM, 1999, 53 (3-4) : 451 - 457
  • [9] HIGH-PRESSURE SYNTHESIS, CHARACTERIZATION, AND EQUATION OF STATE OF CUBIC C-BN SOLID-SOLUTIONS
    KNITTLE, E
    KANER, RB
    JEANLOZ, R
    COHEN, ML
    [J]. PHYSICAL REVIEW B, 1995, 51 (18): : 12149 - 12156
  • [10] Nanoindentation hardness, abrasive wear, and microstructure of TiN/NbN polycrystalline nanostructured multilayer films grown by reactive magnetron sputtering
    Ljungcrantz, H
    Engstrom, C
    Hultman, L
    Olsson, M
    Chu, X
    Wong, MS
    Sproul, WD
    [J]. JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A-VACUUM SURFACES AND FILMS, 1998, 16 (05): : 3104 - 3113