Texture and microhardness of Mg-Rare Earth (Nd and Ce) alloys processed by high-pressure torsion

被引：46

作者：

Bourezg, Yousf Islem ^{[1
]}

Azzeddine, Hiba ^{[1
,2
]}

Baudin, Thierry ^{[3
]}

Helbert, Anne-Laure ^{[3
]}

Huang, Yi ^{[4
]}

Bradai, Djamel ^{[1
]}

Langdon, Terence G. ^{[4
]}

机构：

[1] USTHB, Fac Phys, Algiers, Algeria

[2] Univ Msila, Dept Phys, Msila, Algeria

[3] Univ Paris Saclay, Univ Paris Sud, UMR CNRS 8182, ICMMO,SP2M, F-91405 Orsay, France

[4] Univ Southampton, Fac Engn & Environm, Mat Res Grp, Southampton SO17 1BJ, Hants, England

来源：

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2018年 / 724卷

基金：

欧洲研究理事会;

关键词：

Mg-Rare Earth alloy; High-pressure torsion; Microhardness; Twinning; Second phase; Texture; FINE-GRAINED MG; SEVERE PLASTIC-DEFORMATION; MAGNESIUM ALLOY; MECHANICAL-PROPERTIES; DYNAMIC RECRYSTALLIZATION; MICROSTRUCTURAL EVOLUTION; HOT DEFORMATION; Y ALLOYS; ZR ALLOY; ZN ALLOY;

D O I：

10.1016/j.msea.2018.03.114

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The influence of high-pressure torsion (HPT) processing on the texture and microhardness of two binary Mg-RE (RE = Nd and Ce) alloys was investigated using X-ray diffraction and Vickers microhardness measurements. Disks cut from the alloys were processed by HPT at room temperature for up to 10 turns. The precipitation products of both alloys were identified using synchrotron radiation. The results show that both alloys exhibit a weak basal texture where the c-axis of most grains is shifted 15(.) from the shear direction. An Mg-1.44Ce (wt%) alloy showed a continuous decrease in the texture strength which may be due to the effect of second precipitation phases (Mg17Ce2 and MgCe2). The microhardness of both alloys increased significantly with increasing HPT turns but levelled-off beyond about one HPT turn. Maximum values of similar to 65 and similar to 96 Hv were achieved which are significantly higher than the hardness of the undeformed Mg-Ce and Mg-Nd alloys.

引用

页码：477 / 485

页数：9

共 74 条

[41] Microstructure and texture evolution in a Cu-Ni-Si alloy processed by equal-channel angular pressing [J].