Mechanical properties of bacterial cellulose synthesised by diverse strains of the genus Komagataeibacter

被引:104
作者
Chen, Si-Qian [1 ,2 ]
Lopez-Sanchez, Patricia [1 ,3 ]
Wang, Dongjie [1 ,4 ]
Mikkelsen, Deirdre [1 ]
Gidley, Michael J. [1 ]
机构
[1] Univ Queensland, ARC Ctr Excellence Plant Cell Walls, Ctr Nutr & Food Sci, Queensland Alliance Agr & Food Innovat, Brisbane, Qld 4072, Australia
[2] Dongguan Univ Technol, Sch Chem Engn & Energy Technol, Dongguan 523808, Peoples R China
[3] RISE Res Inst Sweden, Agrifood & Biosci, Gothenburg, Sweden
[4] Tianjin Univ Sci & Technol, Coll Food Engn & Biotechnol, 29 13th Ave, Tianjin 300457, Peoples R China
基金
澳大利亚研究理事会;
关键词
Bacterial cellulose hydrogel; Tensile test; Compression test; Small amplitude oscillatory rheology; Poroelasticity; CELL WALL ANALOGS; ACETOBACTER-XYLINUM; GEL MODULUS; COMPOSITES; CULTURE; POLYSACCHARIDES; PRODUCTIVITY; COMPRESSION; NETWORKS; PLATE;
D O I
10.1016/j.foodhyd.2018.02.031
中图分类号
O69 [应用化学];
学科分类号
081704 ;
摘要
Bacterial cellulose (BC) has several current and potential future uses in the food industry because of its ability to form hydrogels with distinctive properties. The texture of BC hydrogels is determined by both the cellulose fibre network and the internal dispersed water. In this study, mechanical properties of hydrated BC synthesised by six different strains of Komagataeibacter genus were investigated with regards to their extensibility, compressive strength, relaxation ability, viscoelasticity and poroelasticity. The stress/strain at failure and Young's modulus were assessed by uniaxial tensile testing. The compressive strength, relaxation ability and viscoelasticity were measured via a series of compression and small amplitude oscillatory shear steps. A poroelastic constitutive modelling simulation was used to investigate the mechanical effects of water movement. The morphology of the BC fibril network under compression was observed via scanning electron microscopy. Results showed that the mechanics of BC were highly dependent on the cellulose concentration, as well as the morphology of the fibril network. BC synthesised by ATCC 53524 was the most concentrated (0.71 wt%), and exhibited high tensile properties, stiffness and storage moduli; whereas comparatively low mechanical properties were noted for BC produced by ATCC 700178 and ATCC 10245, which contained the lowest cellulose concentration (0.18 wt%). Small deformation responses (normal stress, G') scaled with cellulose concentration for all samples, whereas larger deformation responses (Young's modulus, poroelasticity) depended on both cellulose concentration and additional factors, presumably related to network morphology. Increasing concentration and compressive coalescence of fibres in the integrated BC network reduced both the relaxation of the normal stress and the movement of water. This research aids the selection of bacterial strains to modulate the texture and mechanical properties of hydrated BC-based food systems. (C) 2018 Elsevier Ltd. All rights reserved.
引用
收藏
页码:87 / 95
页数:9
相关论文
共 41 条
[1]   Poroelastic creep response analysis of a lumbar motion segment in compression [J].
Argoubi, M ;
ShiraziAdl, A .
JOURNAL OF BIOMECHANICS, 1996, 29 (10) :1331-1339
[2]   Tensile deformation of bacterial cellulose composites [J].
Astley, OM ;
Chanliaud, E ;
Donald, AM ;
Gidley, MJ .
INTERNATIONAL JOURNAL OF BIOLOGICAL MACROMOLECULES, 2003, 32 (1-2) :28-35
[3]   Structure of Acetobacter cellulose composites in the hydrated state [J].
Astley, OM ;
Chanliaud, E ;
Donald, AM ;
Gidley, MJ .
INTERNATIONAL JOURNAL OF BIOLOGICAL MACROMOLECULES, 2001, 29 (03) :193-202
[4]   Micromechanical model of biphasic biomaterials with internal adhesion: Application to nanocellulose hydrogel composites [J].
Bonilla, Mauricio R. ;
Lopez-Sanchez, P. ;
Gidley, M. J. ;
Stokes, J. R. .
ACTA BIOMATERIALIA, 2016, 29 :149-160
[5]   Never-dried bacterial cellulose/fibrin composites: preparation, morphology and mechanical properties [J].
Brown, Elvie E. ;
Zhang, Jinwen ;
Laborie, Marie-Pierre G. .
CELLULOSE, 2011, 18 (03) :631-641
[6]   Kinetic aspects of bacterial cellulose formation in nata-de-coco culture system [J].
Budhiono, A ;
Rosidi, B ;
Taher, H ;
Iguchi, M .
CARBOHYDRATE POLYMERS, 1999, 40 (02) :137-143
[7]   Anisotropic swelling and mechanical behavior of composite bacterial cellulose-poly(acrylamide or acrylamide-sodium acrylate) hydrogels [J].
Buyanov, A. L. ;
Gofman, I. V. ;
Revel'skaya, L. G. ;
Khripunov, A. K. ;
Tkachenko, A. A. .
JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS, 2010, 3 (01) :102-111
[8]   Bacterial cellulose produced by a new acid-resistant strain of Gluconacetobacter genus [J].
Castro, Cristina ;
Zuluaga, Robin ;
Alvarez, Catalina ;
Putaux, Jean-Luc ;
Caro, Gloria ;
Rojas, Orlando J. ;
Mondragon, Inaki ;
Ganan, Piedad .
CARBOHYDRATE POLYMERS, 2012, 89 (04) :1033-1037
[9]   Mechanical properties of primary plant cell wall analogues [J].
Chanliaud, E ;
Burrows, KM ;
Jeronimidis, G ;
Gidley, MJ .
PLANTA, 2002, 215 (06) :989-996
[10]   Characterisation of bacterial cellulose from diverse Komagataeibacter strains and their application to construct plant cell wall analogues [J].
Chen, Si-Qian ;
Mikkelsen, Deirdre ;
Lopez-Sanchez, Patricia ;
Wang, Dongjie ;
Martinez-Sanz, Marta ;
Gilbert, Elliot P. ;
Flanagan, Bernadine M. ;
Gidley, Michael J. .
CELLULOSE, 2017, 24 (03) :1211-1226