Correlation between OH concentration and oxygen isotope diffusion rate in diopsides from the Adirondack Mountains, New York

The concentration of structural OH in diopside was determined for four granulite facies siliceous marble samples from the Adirondack Mountains, New York, using FTIR spectroscopy. Single-crystal polarized IR spectra were measured on (100) and (010) sections of diopside. The relative intensities of four OH bands in the 3700-3200 cm(-1) region vary among the samples, with the 3645 cm(-1) band dominating the spectra of diopside from a xenolith at Cascade Slide. Total OH content in the diopsides ranges from 55 to 138 ppm H2O by weight. The OH concentration in diopside increases monotonically with increasing f(H2O) for the sample, as estimated using oxygen isotope systematics for diffusion rates in these samples from Edwards and Valley (1998). There is no significant variation in OH content within a single diopside grain or among diopside grains from the same hand sample. Charge-coupled substitution with M3+ and Ti4+ in the crystal structure may have allowed retention of OH in the diopside structure during and after peak metamorphism (similar to750 degreesC, 7-8 kbar). The Cascade Slide diopsides have an Fe3+/Fe2+ of 0.98, compared to Fe3+/Fe2+ (0 to 0.05) for the other samples, implying that some loss of hydrogen through oxidation of Fe was possible in this sample. This is the first study we know of which shows that the OH content in anhydrous minerals from natural samples correlates to the rate of oxygen isotope diffusion.