An experimental analysis of magnetic abrasives finishing of plane surfaces

被引：48

作者：

Girma, Berhanu

Joshi, Suhas S. ^{[1
]}

Raghuram, M. V. G. S.

Balasubramaniam, R.

机构：

[1] Indian Inst Technol, Dept Mech Engn, Bombay 400076, Maharashtra, India

[2] Bhabha Atom Res Ctr, Machine Dynam Div, Precis Engn Sect, Bombay 400085, Maharashtra, India

来源：

MACHINING SCIENCE AND TECHNOLOGY | 2006年 / 10卷 / 03期

关键词：

magnetic abrasive finishing; material removal; surface finish; surface roughness; response surface method;

D O I：

10.1080/10910340600902140

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Magnetic abrasive finishing (MAF) uses magnetic force of very low magnitude applied on ferromagnetic abrasive particles to obtain very high level surface finish. The process has been investigated extensively in the finishing of cylindrical surfaces. This paper reports an experimental work on the analysis of surface roughness and material removal using response surface method in the MAF of plane surfaces. The surface finish was found to improve significantly with an increase in the grain size, relative size of abrasive particles vis-a-vis the iron particles, feed rate and current. The optimum parameter levels which gave better surface finish and the higher material removal were also obtained from this experimentation.

引用

页码：323 / 340

页数：18

共 27 条

[1]

ANZAI M, 1993, INT JAPAN SOC PRECIS, V27, P323

[2] Study on cylindrical magnetic abrasive finishing using unbonded magnetic abrasives [J].