Effects of soil layering on the characteristics of basin-edge induced surface waves and differential ground motion

This paper studies the effects of soil layering in the basin based on the characteristics of basin-edge induced surface waves and associated differential ground motion. Seismic responses of various basin-edge models were simulated using software based on parsimonious finite difference staggered grid approximation of 2.5D elastodynamic wave equation. Seismic responses of various models with different number of soil/soft rock layers but for a fixed thickness of deposit, fundamental frequency and impedance contrast revealed a decrease of surface wave amplitude with an increase in the number of layers in the basin. Shifting of dominant frequency towards the higher values was obtained with an increase of number of layers. An increase of dispersion of surface waves with an increase of number of soil layers in the basin was observed. A minor increase of Rayleigh wave velocity with an increase of number of soil layers was also obtained, but in the case of Love wave it was almost negligible. Spectral analysis of the edge-induced surface waves revealed that the anomalous earthquake intensity may arise in a zone of width of 2.5-3.0 km, parallel to basin-edge and at an offset of 0.5-0.7km from the edge. Maximum horizontal differential ground motion (HDGM) developed by Love wave (approximate to 4.9 x 10(-2)) was more than that of Rayleigh wave (approximate to 9.4 X 10(-3)). Large variation in HDGM caused by the surface waves was obtained with a change in the number of layers in the basin and maximum HDGM was observed when there were only two layers in the basin. It was inferred that the effect of soil layering in the basin was more on the Rayleigh wave as compared to the Love wave. Development of large HDGM near the basin-edge and its dependency on the number of soil layers reveals that basin-edge induced surface waves need special attention during seismic microzonation or seismic hazard prediction.