Consumable selection for arc welding between Stainless Steel 410 and Inconel 718

Dissimilar welding was achieved between martensitic stainless steel type AISI 410 and Inconel 718 using Cold Wire Gas Tungsten Arc Welding (CW-GTAW).Two types of consumables namely 718-410 and 82-410 were selected for this study. In both weldments, the microstructure investigation showed fully austenitic weldments with formation of secondary phases. Secondary phases were present in the heat affected zone (HAZ) of 718, and an unmixed melted zone (UMMZ) Was observed on the 410 interface. The hardness of the secondary phases and UMMZ were determined using nano -indentation, and results revealed higher hardness in these regions compared to the weld zone (WZ) matrix. The UMMZ was removed by arc current enhancement. Mechanical examinations indicated that secondary phases and UMMZ did not significantly affect tensile strength and resistance to plastic deformation. However, investigation revealed that secondary phases can have a detrimental effect on ductility. Filler wire 82-410 demonstrated improved mechanical properties compared to filler 718-410 at room temperature and resulted in a stronger weld compared to 410 base metal (BM). (C) 2017 Elsevier B.V. All rights reserved.