Insulation Characteristics of GIS Insulators under Lightning Impulse with DC Voltage Superimposed

To study the dc insulation design of gas insulated switchgear (GIS), the insulation characteristics under lightning impulse (LI) voltage with a superimposed dc voltage (superimposed voltage) must be clarified. The paper experimentally examined the GIS breakdown characteristics under this superimposed voltage. The test models simulating an insulator creepage surface were used for which consideration of the influence of dc voltage among various other GIS insulating elements is particularly important. To be specific, a cylindrical model made of epoxy resin or fiber-reinforced plastic (FRP) as the material and a conical epoxy spacer model were tested. For the cylindrical model, a cap-shaped electrode was placed on the insulator and a small gap was established between the end of the electrode and the insulator. When the dc breakdown voltages were measured using these samples, they were higher for the applied voltage of positive polarity than that of negative polarity for all samples. The post-test observation of the electrification condition revealed greater electrification on the insulator surface for the applied voltage of positive polarity. The electrification charges are considered to have relaxed the electric field and increased the breakdown voltage. Subsequently, the breakdown test was conducted using a superimposed voltage, whereby a foregoing dc voltage was applied to samples for a certain period, whereupon a LI voltage was applied with the dc voltage continually applied. The breakdown voltage when the LI voltage and dc voltage had equivalent polarity was approximately same to the LI alone breakdown voltage. Conversely, when they were opposite in polarity, the breakdown voltage under the superimposed voltage obviously tended to decrease from the LI alone breakdown voltage. It is considered attributable to the fact that the insulator surface was electrified by the foregoing dc voltage and applying LI voltage opposite in polarity to this electrification intensified the electric field where the breakdown started to occur. Accordingly, it emerged that the GIS breakdown characteristics changed significantly depending on the polarity combinations of LI and dc voltages. The influence of these polarities must be taken into consideration when studying the GIS dc insulation design.