Microstructuring by selective laser sintering of metallic powder

被引：82

作者：

Kathuria, YP ^{[1
]}

机构：

[1] Laser X Co Ltd, Chiryu, Aichi 472, Japan

来源：

SURFACE & COATINGS TECHNOLOGY | 1999年 / 116卷

关键词：

laser sintering; microfabrication;

D O I：

10.1016/S0257-8972(99)00266-2

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

This payer describes recent work carried out on three-dimensional microstructuring by beam technology - both one-component solid-state laser sintering and two-metal liquid-phase selective laser sintering of metallic powders with high and low melting points. The results show that, due to the surface contact only, the feature size obtained with one-component solid-state sintering is smaller than that with two-metal liquid-phase sintering. The influence of the processing conditions on the type of phases and microstructure evolution are considered. Attempts were also made to create fine structures with the composite powder materials. A few brief examples are demonstrated. (C) 1999 Elsevier Science S.A. All rights reserved.

引用

页码：643 / 647

页数：5

共 9 条

[1] Jacobs P.F., 1992, Rapid prototyping and manufacturing. Fundamentals of stereolithography
[2] KATHURIA YP, 1997, P 8 INT S MICR HUM S, P41
[3] KATHURIUA YP, 1997, P MIPE JSME, V97, P302
[4] Kim J. D., 1997, P 30 ISATA, P201
[5] KRUTH JP, 1991, ANN CIRP, V40, P603
[6] MEINERS W, 1996, P ECLAT STUTTG GERM, P879
[7] Routes to plastic models and prototypes using the SLS(R) selective laser sintering process
Seitz, S
vandeCrommert, S
Esser, KJ
McAlea, K
[J]. RAPID PROTOTYPING AND FLEXIBLE MANUFACTURING, 1997, 3102 : 106 - 111
[8] THORNELL G, 1997, P MICR INF PREC EQ J, P309
[9] VANDERSCHUEREN B, 1995, MANUFACTURING SYSTEM, V24, P517

← 1 →