Evaluation of Arc Signals, Microstructure and Mechanical Properties in Ultrasonic-Frequency Pulse Underwater Wet Welding Process with Q345 Steel

The ultrasonic-frequency pulse underwater wet welding (UFP-UWW) process was achieved through a constant-voltage-mode power source connecting an ultrasonic-frequency pulse power source in parallel. The arc voltage and welding current waveforms, sound signal variations, microstructural characteristics and mechanical properties at different parameters were investigated. The results showed that the ultrasonic-frequency pulse voltage and current of the UFP-UWW process displayed a periodic high-frequency oscillation on the based values of the conventional UWW process. The arc stability of the UFP-UWW process improved owing to the fact that the proportions of the unstable arc burning region could be reduced to 1.56% after the introduction of the ultrasonic-frequency pulse current. No significant changes in weld width and penetration were observed while the weld dilution rate increased to 54.2% for the combination of 40 V-30 kHz, compared with the results of the conventional UWW process. The flux-cored arc (FCA) welding arc in the air had the same frequency response to the ultrasonic excitation signal, which verified the existence of the ultrasonic-frequency vibration induced by the periodic high-frequency electromagnetic forces. The application of the ultrasonic-frequency pulse produced finer columnar grains in the welds with an average length of 315 mu m, although the amount of pro-eutectoid ferrite and acicular ferrite varied little. The mechanical properties of the welded joints were also noticeably enhanced with the application of different ultrasonic excitation frequencies. The optimum tensile strength and impact toughness of the welded joint were improved by 6.7% and 21.7% when the applied ultrasonic excitation voltage was 40 V for a pulsed frequency of 30 kHz. These results facilitate the application of ultrasonic arc welding technology in the marine field.