Residual stress and mechanical property measurements in amorphous Si photovoltaic thin films

The mechanical reliability and efficiency of thin film photovoltaics attached to structural members depends on the initial state of residual stresses in the films. In this work, predictions for the mechanical and functional failure of photovoltaic films co-cured with carbon fiber composite laminates were made possible by quantifying the mean and gradient residual stresses and the failure properties of the individual layers in thin film inorganic photovoltaics consisting of an amorphous silicon (Si) p-n junction diode, a zinc oxide (ZnO) Transparent Conductive Oxide (TCO) layer (each 1 pm thick), a Kapton (TM) layer, and a thick aluminum substrate. The mean residual stresses (-466 +/- 118) MPa in the Si monolayer and the Si/ZnO bilayer (-661 +/- 93) MPa were calculated from the geometrical details of straight and telephone cord type buckling delaminations induced to the p-n junction layer and its combination with the TCO layer, respectively. Curvature measurements provided the residual stress gradient of the Si monolayer as 274 +/- 20 MPa/mu m and the stress gradient profile in the Si/ZnO bilayer. The tensile strength of freestanding amorphous Si monolayer and Si/ZnO bilayer strips was measured as 425 75 MPa and 109 23 MPa, respectively. These microscale tension experiments also showed that there is weak adhesion between the Si and the mechanically weak ZnO layers. The aforementioned experimental results were employed to predict the onset of fragmentation of the ZnO layer and the initiation of functional degradation of the photovoltaic films that were co-cured with 0 degrees carbon fiber composite laminates, at 0.3% and 0.9% applied strain, respectively, which was in very good agreement with experimental measurements at the composite level. (C) 2014 Elsevier Ltd. All rights reserved.