Properties of electrodeposited Co-Mn films: Influence of deposition parameters

被引:10
|
作者
Karpuz, Ali [1 ]
Kockar, Hakan [2 ]
Alper, Mursel [3 ]
机构
[1] Karamanoglu Mehmetbey Univ, Dept Phys, Kamil Ozdag Sci Fac, Karaman, Turkey
[2] Balikesir Univ, Dept Phys, Sci & Literature Fac, Balikesir, Turkey
[3] Uludag Univ, Dept Phys, Sci & Literature Fac, Bursa, Turkey
关键词
Co-Mn alloys; Electrodeposition; Structural characterization; Magnetic propertiesa; MAGNETIC-PROPERTIES; NI-CO; INPLANE ANISOTROPY; ALLOYS; GROWTH; ELECTROLYTES; PERFORMANCE; POTENTIALS; THICKNESS; ROTATION;
D O I
10.1016/j.apsusc.2015.08.179
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Co-Mn films were produced with electrodeposition considering the deposition parameters of electrolyte pH value, Mn concentration of the electrolyte and film thickness. The effect of each parameter on the structural, magnetic and magnetoresistance properties of the films was studied, separately. X-ray diffraction measurement showed that the films have hexagonal close packed structure. For the films deposited at different pH values, the surface morphologies with different-sized globular granules were observed whereas the morphology covered by uniformly distributed nanoscale grains was detected for the surfaces of all films produced from electrolytes with different Mn concentrations. Also, the ribbed surfaces for 6 mu m and 4 mu m, and the nano-sized acicular surface morphologies for 2 mu m were observed. To the results of magnetic measurements, the saturation magnetization was found to be 1230 emu/cm(3) for all films deposited at different electrolyte pHs. The highest remanent magnetization value was obtained to be 882 emu/cm(3) for the film produced from the electrolyte containing 0.06 M Mn concentration. The coercivity, H-c, values decreased from 147 Oe to 43 Oe when the electrolyte pH decreased from 4.7 to 2.6. And, the Hc continued to decrease from 45 Oe to 31 Oe when the Mn concentration increased from 0.02 M to 0.06 M, and from 27 Oe to 22 Oe when the film thickness decreased from 6 pin to 2 mu m. It is seen that the Hc was immensely affected by the deposition parameters applied during the film production. The Co-Mn films with low Hc were achieved using relatively low electrolyte pH, high Mn concentration of electrolyte and low film thickness, respectively. Also, influence of the deposition parameters affect Hc is in order of the electrolyte pH, the Mn concentration in the electrolyte and the film thickness (from high to low influence). As it is observed that the magnetic properties are sensible to the deposition parameters and the Co-Mn films may have the potential applications in magnetic recording and sensors technologies. (C) 2015 Elsevier B.V. All rights reserved.
引用
收藏
页码:605 / 611
页数:7
相关论文
共 50 条
  • [11] Low temperature combustion synthesis and magnetostructural properties of Co-Mn nanoferrites
    Salunkhe, A. B.
    Khot, V. M.
    Phadatare, M. R.
    Thorat, N. D.
    Joshi, R. S.
    Yadav, H. M.
    Pawar, S. H.
    JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 2014, 352 : 91 - 98
  • [12] Influence of the aluminum incorporation on the properties of electrodeposited ZnO thin films
    El Hichou, Ahmed
    Diliberto, Sebastien
    Stein, Nicolas
    SURFACE & COATINGS TECHNOLOGY, 2015, 270 : 236 - 242
  • [13] Effect of Deposition Potential on Structure and Magnetic Properties of Electrodeposited FeCoCu Thin Films
    Shrivastava, Shreesh Kumar
    Khatri, Manvendra Singh
    Agarwal, Shivani
    JOURNAL OF ELECTRONIC MATERIALS, 2025, 54 (03) : 2009 - 2017
  • [14] Moment variations in disordered Co-Mn alloys
    Hicks, TJ
    Ling, MF
    PHYSICA B, 2000, 276 : 744 - 745
  • [15] Impact of substrate on the formation mechanism of electrodeposited Co-Ni thin films: a comprehensive study of structural, morphological, and magnetic properties
    Boulegane, A.
    Guittoum, A.
    Larbi, Abderrahim Hadj
    Laggoun, A.
    Boudissa, M.
    APPLIED PHYSICS A-MATERIALS SCIENCE & PROCESSING, 2024, 130 (05):
  • [16] Effect of deposition and annealing parameters on the properties of electrodeposited CuIn1-xGaxSe2 thin films
    Bouabid, K
    Ihial, A
    Manar, A
    Outzourhit, A
    Ameziane, EL
    THIN SOLID FILMS, 2005, 488 (1-2) : 62 - 67
  • [17] Influence of seed layer thickness on properties of electrodeposited ZnO nanostructured films
    Reyes Tolosa, M. D.
    Alajami, M.
    Montero Reguera, A. E.
    Damonte, L. C.
    Hernandez-Fenollosa, M. A.
    SN APPLIED SCIENCES, 2019, 1 (10):
  • [18] Understanding the ORR Electrocatalysis on Co-Mn Oxides
    Wang, Wang
    Liu, Ershuai
    Hu, Youcheng
    Jiao, Li
    Kolla, Praveen
    Liu, Yucheng
    Tang, Meihua
    Luo, Jin
    Sun, Qiang
    Chen, Shengli
    Jia, Qingying
    Mukerjee, Sanjeev
    JOURNAL OF PHYSICAL CHEMISTRY C, 2021, 125 (46) : 25470 - 25477
  • [19] Investigation the effect of annealing parameters on the physical properties of electrodeposited ZnS thin films
    Zakerian, Farbod
    Kafashan, Hosein
    SUPERLATTICES AND MICROSTRUCTURES, 2018, 124 : 92 - 106
  • [20] Giant Magnetoresistance in Electrodeposited Films: Current Status and the Influence of Parameters
    Rajasekaran, N.
    Mohan, S.
    CRITICAL REVIEWS IN SOLID STATE AND MATERIALS SCIENCES, 2012, 37 (03) : 158 - 180