Surface modification behaviors of glass-like carbon by oxygen ion implantation

被引：6

作者：

Nakamura, Kazumasa ^{[1
]}

Teranishi, Yoshikazu ^{[2
]}

Wada, Yukako ^{[1
]}

Tano, Ko-ichiro ^{[1
]}

Nakamura, Isao ^{[2
]}

Tanabe, Yasuhiro ^{[3
]}

Yasuda, Eiichi ^{[4
]}

Akatsu, Takashi ^{[4
]}

Shindo, Hitoshi ^{[1
]}

机构：

[1] Chuo Univ, Fac Sci & Engn, Dept Appl Chem, Tokyo 1128551, Japan

[2] Tokyo Metropolitan Ind Technol Res Inst TIRI, Tokyo, Japan

[3] Nagoya Univ, Grad Sch Engn, Dept Chem Engn, Nagoya, Aichi 4648601, Japan

[4] Tokyo Inst Technol, Mat & Struct Lab, Tokyo, Japan

来源：

NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS | 2009年 / 267卷 / 8-9期

关键词：

Carbon alloy; Glass-like carbon; Ion implantation; Surface modification; Biological affinities; IMPROVEMENT;

D O I：

10.1016/j.nimb.2009.01.093

中图分类号：

TH7 [仪器、仪表];

学科分类号：

0804 ; 080401 ; 081102 ;

摘要：

Surface modification behaviors of glass-like carbon (GLC) by oxygen ion implantation were studied at the ionic doses of 1, 10 and 100 x 10(14) ions/cm(2). Formation of bank network at the GLC surface, following initial smoothing, was observed with atomic force microscopy (AFM). At the same time, Friction coefficient and surface roughness decreased at the ionic dose of 1 x 10(14) ions/cm(2), but increased again at higher doses. Increase in surface disorder at lower ionic dose and change to amorphous at higher doses were detected with Raman spectroscopy. As O/C ratio measured with X-ray photoelectron spectroscopy (XPS) increased with the ionic dose, the contact angle of the GLC surface with water decreased. The most biocompatible GLC surface was obtained at the dose of 1 x 10(14) ions/cm(2). (C) 2009 Elsevier B.V. All rights reserved.

引用

页码：1642 / 1644

页数：3

共 12 条

[1] Comparison between surface properties of F- and HF-implanted glassy carbon
Iwaki, M
[J]. SURFACE & COATINGS TECHNOLOGY, 2005, 196 (1-3) : 246 - 250
[2] IMPROVEMENT OF WEAR PROPERTIES OF GLASSY-CARBON SURFACE-LAYER MODIFIED BY ION IMPLANTATIONS
IWAKI, M
TAKAHASHI, K
YOSHIDA, K
OKABE, Y
[J]. NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS, 1989, 39 (1-4) : 700 - 703
[3] Iwaki M., 1999, P IEEE INT C ION IMP, P1026
[4] Katagiri G., 1996, Tanso, V175, P304
[5] ION-BEAM-INDUCED COMPACTION IN GLASSY-CARBON
MCCULLOCH, D
HOFFMAN, A
PRAWER, S
[J]. JOURNAL OF APPLIED PHYSICS, 1993, 74 (01) : 135 - 138
[6] STRUCTURAL INVESTIGATION OF XENON-ION-BEAM-IRRADIATED GLASSY-CARBON
MCCULLOCH, DG
PRAWER, S
HOFFMAN, A
[J]. PHYSICAL REVIEW B, 1994, 50 (09): : 5905 - 5917
[7] RAMAN-SPECTROSCOPIC INVESTIGATION OF ION-BEAM-IRRADIATED GLASSY-CARBON
PRAWER, S
NINIO, F
BLANCHONETTE, I
[J]. JOURNAL OF APPLIED PHYSICS, 1990, 68 (05) : 2361 - 2366
[8] EFFECT OF TARGET TEMPERATURE DURING NITROGEN ION-IMPLANTATION ON ELECTROCHEMICAL PROPERTIES OF ION-IMPLANTED GLASSY-CARBON
TAKAHASHI, K
IWAKI, M
WATANABE, H
[J]. JOURNAL OF ELECTROANALYTICAL CHEMISTRY, 1995, 396 (1-2): : 541 - 546
[9] Improvement in surface roughness of nitrogen-implanted glassy carbon by hydrogen doping
Takahiro, K
Ookawa, R
Kawatsura, K
Nagata, S
Nishiyama, F
Yamamoto, S
Narumi, K
Naramoto, H
Iwaki, M
[J]. DIAMOND AND RELATED MATERIALS, 2003, 12 (08) : 1362 - 1367
[10] Surface graphitization of Furan-resin-derived carbon
Tanabe, Y
Yamanaka, J
Hoshi, K
Migita, H
Yasuda, E
[J]. CARBON, 2001, 39 (15) : 2347 - 2353

← 1 2 →