Pulse Shaping: The Missing Piece of Backscatter Radio and RFID

The increasing use of backscatter radio for pervasive Internet-of-Things systems as a low-power and low-cost communication scheme will result in dense deployments of tags that need to operate under bandwidth (BW) constraints. Typical backscatter tags and computational radio frequency (RF) identification systems are unnecessarily limited to modulating data with "ON-OFF" switching front-ends, which leads to extensive spectrum occupancy, due to the rectangular pulses. This paper sets the foundations to overcome these limitations and proposes designs of RF front-ends that are capable of varying the tag reflection coefficient in a continuous way over time. Arbitrary waveforms can be generated to perform pulse shaping on the backscattered signals, which require significantly reduced BW. The principles presented in this paper will enable sophisticated tags to perform complex modulation schemes under BW constraints, while maintaining a very low RF front-end complexity, using a single nonlinear component such as a p-i-n diode or field-effect transistor. Migrating the idea of pulse shaping from complex power-demanding active radios to such minimal RF front-ends will complete backscatter radio as a communication scheme for simple RF tags and sensors in large-scale deployments. Each tag becomes a miniature software-defined radio that implements diverse communication schemes with increased spectral efficiency.