Effect of microstructure on the fatigue crack growth behavior of Cu-Be-Co-Ni alloy

The fatigue crack growth (FCG) behaviors of Cu-Be-Co-Ni alloy subjected to interrupted aging (IA), normal aging (NA) and overaging (OA) treatment were discussed. The distinctions in microstructure of the alloys after various aging treatments led to different FCG behaviors. In order to understand the different FCG behaviors, a model based on the reversible plastic zone (RPZ) size and microstructural factors was applied in this study. At the relatively low stress intensity factor range (Delta K < 17 MPa m(1/2)), the RPZ size of each sample was smaller than the corresponding grain size, so the fatigue crack propagated inside the grain and adjacent to the grain boundaries (GBs). For the IA alloy, fine and coherent gamma '' precipitates which could be sheared by dislocations promoted the fatigue crack resistance, leading to the decrease of FCG rate. When the value of stress intensity factor range becomes higher (Delta K > 21 MPa m(1/2)), the RPZ size of each sample was 1-2 times of the corresponding grain size. Consequently, the crack trended to grow along GBs. For the OA alloy, the crack propagated along the interfaces between the discontinuous precipitation (DP) cells and parent phase. The tortuous interfaces hindered the propagation of the fatigue cracks, resulting in the reduction of FCG rate. (C) 2015 Elsevier B.V. All rights reserved.