Study of Ar + O2 deposition pressures on properties of pulsed laser deposited CdTe thin films at high substrate temperature

Cadmium telluride (CdTe) thin films deposited by pulsed laser deposition (PLD) on fluorine-tin-oxide substrates under different pressures of argon (Ar) + oxygen (O-2) at high substrate temperature (T-s = 500 A degrees C) was reported in this paper. In our work, the CdTe thin films were prepared successfully at high T-s by inputting Ar + O-2. As reported, PLD-CdTe thin films were almost prepared at low substrate temperatures (< 300 A degrees C) under vacuum conditions. The deposition of CdTe thin films at high T-s by PLD is rarely reported. The influence of the Ar + O-2 gas pressure on thickness, structural performance, surface morphology, optical property and band gap (E-g) had been investigated respectively by Ambios probe level meter, X-ray diffraction (XRD), scanning electron microscopy (SEM) and UV-Vis spectrometer. Strong dependence of properties on the deposition pressures was revealed. In the range of Ar + O-2 gas pressure from 5 to 12 Torr, the deposition rate and the E-g of CdTe films vary in the range of 41.9-57.66 nm/min then to 35.26 nm/min and 1.51-1.54 eV then to 1.47 eV, respectively. The XRD diagrams showed that the as-deposited films were polycrystalline, and the main phase was cubic phase. However, the preferred orientation peak disappeared when the deposition pressure was higher. SEM images indicated that the CdTe film deposited at a higher deposition pressure was more uniform and had a higher compactness and a lower pinhole density. Furthermore, based on this thorough study, FTO/PLD-CdS (100 nm)/PLD-CdTe (similar to 1.5 mu m)/HgTe:Cu/Ag solar cells with an efficiency of 6.68 % and an area of 0.64 mm(2) were prepared successfully.