Change of steels and alloys structure and properties during long operation at high temperature

被引:1
|
作者
Getsov, LB [1 ]
Rybnikov, AI [1 ]
Pigrova, GD [1 ]
机构
[1] Polzunov Cent Boiler & Turbine Inst, St Petersburg 194021, Russia
来源
JOURNAL DE PHYSIQUE IV | 1999年 / 9卷 / P9期
关键词
D O I
10.1051/jp4:1999911
中图分类号
O4 [物理学];
学科分类号
0702 ;
摘要
When defining the stress-strain state (SSS) and evaluating safety factors for turbomashinery components operating at high temperatures under creep conditions, deformation and fracture characteristics obtained during tests of as-heat-treated materials are usually used. At the same time, if the change in material properties during long - term service is taken into account, then the SSS of companents and, consequently, the real safety factors can significantly differ from design values which have been calculated without accounting for these changes. In this report the changes in material structure and deformation characteristics, stress-rupture and creep-rupture properties, and thermal fatigue for a number of materials of different types (perlitic and austenitic steel, nickel-base alloys) are analyzed based on the results of long-standing studies were performed for the materials both in the original state and after long-term aging (to 10000 hour and in some cases up to 50.0000 hour and up) at high temperatures (400-900 degrees C). The greatest changes in properties were found for 20Ch23N18 austenitic steel and EP99 nickel-base alloy (22%Cr) after long-term aging, resulting in topologically close-packed sigma- and mu- phases precipitations. Thus, EP99 alloy plasticity is decreased to about zero at 20 degrees C, number of cycles to failure is hundred times reduced thermal fatigue tests. The rate of creep for 20Ch23N18 steel 20X23H18 is 150 times increased.
引用
收藏
页码:105 / 115
页数:11
相关论文
共 50 条
  • [21] Internal Nitriding of High-Temperature Steels and Alloys
    L. G. Petrova
    Metal Science and Heat Treatment, 2001, 43 : 11 - 17
  • [22] Internal nitriding of high-temperature steels and alloys
    Petrova, LG
    METAL SCIENCE AND HEAT TREATMENT, 2001, 43 (1-2) : 11 - 17
  • [23] Changes in the structure and properties of steels and alloys at elevated temperatures
    Getsov, L.B.
    Rybnikov, A.I.
    Pigrova, G.D.
    Thermal Engineering, 2000, 47 (04) : 308 - 315
  • [24] Influence of laser radiation on structure and properties of steels and alloys
    Tarasova, T.
    Popova, E.
    NAMES10: NEW ACHIEVEMENTS IN MATERIALS AND ENVIRONMENTAL SCIENCES, 2013, 416
  • [25] Particle structure change of CaO during high temperature sulphatization
    Bjerie, Ingesnur
    Ye, Zhicheng
    Chemical Engineering and Technology, 1991, 14 (05): : 357 - 362
  • [26] INFLUENCE OF HIGH-TEMPERATURE DEFORMATION ON STRUCTURE AND PROPERTIES OF ISOTHERMALLY QUENCHED STEELS
    SMIRNOV, MA
    SHTEYNBERG, MM
    SCHASTLIVTSEV, VM
    FILATOV, VI
    YAKOVLEVA, IL
    PATRAKOV, YI
    FIZIKA METALLOV I METALLOVEDENIE, 1979, 48 (04): : 816 - 825
  • [27] MECHANISM OF INFLUENCE OF MAGNESIUM ON STRUCTURE AND PROPERTIES OF HIGH-TEMPERATURE ALLOYS
    TOPILIN, VV
    STEEL IN THE USSR, 1978, 8 (11): : 643 - 646
  • [28] MECHANISM OF INFLUENCE OF MAGNESIUM ON STRUCTURE AND PROPERTIES OF HIGH-TEMPERATURE ALLOYS
    Topilin, V.V.
    1978, 8 (11): : 643 - 646
  • [29] Properties of Stainless Steels and High Temperature Resisting Alloys Produced by Special Melting Processes.
    Spitzer, Horst
    1600, (92):
  • [30] Changes of microstructures and high temperature properties during high temperature service of Niobium added ferritic stainless steels
    Fujita, N
    Ohmura, K
    Yamamoto, A
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2003, 351 (1-2): : 272 - 281