Effects of titanium addition and section size on microstructure and mechanical properties of compacted graphite cast iron

Titanium is an anti-spheroidizing element and also carbide former in ductile iron. On the other hand, increasing the casting size essentially lowers the cooling rate that opposes the chilling tendency of titanium. This research was to study;the combined effects of titanium and section size on their promotion of compacted graphite (CG) formation, and at the same time how matrix constituents were altered in heavy-wall castings. It was found that at the increasing casting thickness of 30 mm, 65 mm and 80 mm, the percentage of CG increased while that of pearlite decreased either with or without titanium addition. However, titanium (added in an amount of 0.15 wt%) effectively promoted the formation of CG by over 10% and at the same time increased the pearlite content in the matrix. This was especially true in the thinner 30 mm casting. Irons with titanium addition exhibited a bit lower Brinell hardness, elongation, and impact toughness due probably to the higher CG percentage that facilitated easier crack propagation. However, comparing to the un-alloyed iron, fracture toughness increased along with: tensile strength for iron with titanium addition in all casting sizes of 30-80mm. The higher pearlite content in the matrix has overidden the effect of increased CG percentage such that tensile strength and K-1C value both increased. (C) 2000 Published by Elsevier Science S.A. All rights reserved.