Macroscopic and microscopic investigations on uniaxial ratchetting of two-phase Ti-6A1-4V alloy

The uniaxial ratchetting of Ti-6A1-4V alloy with two phases (i.e., primary hexagonal close packed (HCP) alpha and secondary body-centered cubic (BCC) beta phases) was investigated by macroscopic and microscopic experiments at room temperature. Firstly, the effects of cyclic softening/hardening feature, applied mean stress and stress amplitude on the uniaxial ratchetting of the alloy were discussed. The macroscopic investigation of Ti-6A1-4V alloy presents obvious strain-amplitude-dependent cyclic softening, as well as a three-staged evolution curve with regard to the ratchetting strain rate. The ratchetting depends greatly on the applied mean stress and stress amplitude while the ratchetting strain increases with the increasing applied mean stress and stress amplitude. Then, the evolution of dislocation patterns and deformation twinning during the uniaxial ratchetting of two-phase Ti-6A1-4V alloy were observed using transmission electron microscopy (TEM). The microscopic observation shows that deformation twinning occurs in the primary a phase and its amount increases gradually during the uniaxial ratchetting. Simultaneously, the planar dislocation evolves from discrete lines to some dislocation nets and parallel lines with the increasing number of cycles. The deformation twinning in the primary a phase is one of main contributions to the uniaxial ratchetting of Ti-6A1-4V alloy, and should be considered in the construction of corresponding constitutive model. (C) 2014 Elsevier Inc. All rights reserved.