Polymerization of methyl methacrylate in the presence of iron(II) complex with tetradentate nitrogen ligands under conditions of atom transfer radical polymerization

Four tetradentate nitrogen ligands, viz. dichlorol{[N,N'-diphenyl-N,N'-di(quinoline-2-methyl)]-1,2-ethylene diamine} (1), {[N,N'-dioctyl-N,N'-di(quinoline-2-methyl)]-1,2-ethylene diamine} (2), {[N,N'-dibenzyl-N,N'-di(quinoline-2-methyl)]-1,2-ethylene diamine} (3), and (1R,2R)-(-)-N,N'-di(quinoline-2-methyl) di-iminocyclohexane (4), were investigated as novel complexing ligands in iron-mediated atom transfer radical polymerization (ATRP) of methyl methacrylate where ethyl-2-bromoisobutyrate was the initiator in o-xylene at 90degreesC. With ligands 1 and 2 the experimental molecular weights increased gradually with monomer conversion. High to moderate conversions (87%, 43%) were obtained in relatively short times (90 min for 1 and 30 min for 2), which indicates an efficient catalyst system, but after these times a dramatic increase in viscosity of the polymerization medium led to loss of control. It is noteworthy that polymerization proceeded in a controlled manner with ligand 1, which has two rather bulky substituents on the N-atom. Such bulky ligands did not work for a copper-based system, where they led to excessive terminations or other side reactions. When the bulkiness of the substituents was significantly increased, as in ligand 3, a decrease in polymerization rate and loss of control occurred. Ligand 4 was less efficient than the other ligands, probably because the ethylene bridge was replaced by cyclohexane bridge. (C) 2004 Elsevier Ltd. All rights