Heat transfer to small horizontal cylinders immersed in a fluidized bed

被引:23
作者
Friedman, J.
Koundakjian, P.
Naylor, D.
Rosero, D.
机构
[1] Ryerson Univ, Dept Mech & Ind Engn, Toronto, ON M5B 2K3, Canada
[2] Univ Waterloo, Dept Mech Engn, Waterloo, ON N2L 3G1, Canada
来源
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME | 2006年 / 128卷 / 10期
关键词
fluidized bed; heat transfer; cylinders;
D O I
10.1115/1.2345425
中图分类号
O414.1 [热力学];
学科分类号
摘要
Heat transfer to horizontal cylinders immersed in fluidized beds has been extensively studied, but mainly in the context of heat transfer to boiler tubes in coal-fired beds. As a result, most correlations in the literature have been derived for cylinders of 25-50 mm diameter in vigorously fluidizing beds. In recent years, fluidized bed heat treating furnaces fired by natural have become increasingly popular, particularly in the steel wire manufacturing industry. These fluidized beds typically operate at relatively low fluidizing rates (G/G(mf)<d) and with small diameter wires (1-6 mm). Nusselt number correlations developed based on boiler tube studies do not extrapolate down to these small size ranges and low fluidizing rates. In order to obtain reliable Nusselt number data for these size ranges, an experimental investigation has been undertaken using two heat treating fluidized beds; one a pilot-scale industrial unit and the other a lab-scale (300 mm diameter) unit. Heat transfer measurements were obtained using resistively heated cylindrical samples ranging from 1.3 to 9.5 mm in diameter at fluidizing rates ranging from approximately 0.5 x G(mf) (packed bed condition) to over 10 x G(mf) using aluminum oxide sand particles ranging from d(p) = 145-330 mu m (50-90 grit). It has been found that for all cylinder sizes tested, the Nusselt number reaches a maximum near 2 x G(mf), then remains relatively steady ( +/- 5 - 10 %) to the maximum fluiding rate tested, typically 8 -12 x G(mf). A correlation for maximum Nusselt number is developed.
引用
收藏
页码:984 / 989
页数:6
相关论文
共 14 条
[11]  
PETRIE JC, 1968, CHEM ENG PROG, V64, P45
[12]   EFFECT OF DISTRIBUTORS ON HEAT-TRANSFER FROM IMMERSED SURFACES IN GAS-FLUIDIZED BEDS [J].
SATHIYAMOORTHY, D ;
RAO, CS ;
RAO, MR .
CHEMICAL ENGINEERING JOURNAL AND THE BIOCHEMICAL ENGINEERING JOURNAL, 1988, 37 (03) :149-163
[13]  
Saxena SC, 1989, ADV HEAT TRANSFER, V19, P97
[14]   HEAT TRANSFER BETWEEN A FLUIDIZED BED AND A HORIZONTAL TUBE [J].
VREEDENBERG, HA .
CHEMICAL ENGINEERING SCIENCE, 1958, 9 (01) :52-60