Rapid sintering of nanocrystalline 8 mol.%Y2O3-stabilized ZrO2 by high-frequency induction heating method

被引：43

作者：

Kim, Hwan-Cheol ^{[1
]}

Shon, In-Jin ^{[1
]}

Jeong, In-Kyoon ^{[1
]}

Ko, In-Yong ^{[1
]}

机构：

[1] Chonbuk Natl Univ, Dept Adv Mat Engn, Res Ctr Adv Mat Dev, Engn Res Inst, Jeonbuk 560756, South Korea

来源：

METALS AND MATERIALS INTERNATIONAL | 2006年 / 12卷 / 05期

关键词：

sintering; mechanical properties; microstructure; nanomaterials; hardness;

D O I：

10.1007/BF03027705

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Using a high-frequency induction-heating sintering (HFIHS) method, nanocrystalline 8 mol.%Y2O3-stabilized ZrO2 was obtained from ultra fine powders. The observed advantages of this process include very quick densification to near theoretical density and prohibition of grain growth in namo-structured materials. Nearly fully dense nanocrystalline 8 mol%Y2O3-stabilized ZrO2, with a relative density of up to 99.8%, could be obtained with simultaneous application of 100 MPa pressure and an induced current within 10 min of sintering time without significant change in grain size. The influences of the sintering temperature and the mechanical pressure on the final density and grain size, of the products were investigated. The hardness and fracture toughness of the dense ZrO2 ceramics produced by HFIHS were investigated.

引用

页码：393 / 398

页数：6

共 50 条

[41] Residual stresses in Al2O3-ZrO2 (3 mol.% Y2O3) directionally solidified eutectic ceramics as a function of temperature [J].

Ramirez-Rico, J. ;

Martinez-Fernandez, J. ;

Pena, J. I. ;

Singh, D. ;

Routbort, J. .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2012, 541 :61-66

[42] Mechanical synthesis and rapid consolidation of nanocrystalline TiCo-Al2O3 composites by high frequency induction heated sintering [J].

Yoon, Jin-Kook ;

Shon, In-Jin .

JOURNAL OF CERAMIC PROCESSING RESEARCH, 2016, 17 (07) :722-726

[43] Microstructure and mechanical properties of ZrO2 fiber toughened Al2O3/ ZrO2(Y2O3) solidified ceramics prepared with high frequency induction zone melting [J].

Lan, Dehui ;

Gao, Rui ;

Liu, Xudong ;

Zhu, Luyi ;

Zheng, Yongting ;

Liu, Juncheng .

JOURNAL OF ALLOYS AND COMPOUNDS, 2023, 967

[44] Apparent Sintering Activation Energy Estimated by Master Sintering Curves for 8 mol% Y2O3 Doped ZrO2 Polycrystals during Shrinkage-Rate Controlled Flash Sintering [J].

Koike M. ;

Kodaira A. ;

Tokunaga T. ;

Yamamoto T. .

Materials Transactions, 2023, 64 (10) :2315-2320

[45] Effect of sintering temperature on the microstructure and mechanical properties of ZrO2-3 mol%Y2O3 sol-gel films [J].

Diaz-Parralejo, A. ;

Ortiz, A. L. ;

Caruso, R. .

CERAMICS INTERNATIONAL, 2010, 36 (08) :2281-2286

[46] Improvement on the phase stability, mechanical properties and thermal insulation of Y2O3-stabilized ZrO2 by Gd2O3 and Yb2O3 co-doping [J].

Guo, Lei ;

Guo, Hongbo ;

Gong, Shengkai ;

Xu, Huibin .

CERAMICS INTERNATIONAL, 2013, 39 (08) :9009-9015

[47] Mechanical synthesis and rapid consolidation of nanostructured FeAl-Al2O3 composites by high-frequency induction heated sintering [J].

Shon, In-Jin ;

Jo, Seung-Hoon ;

Doh, Jung-Mann ;

Yoon, Jin-Kook ;

Park, Bang-Ju .

CERAMICS INTERNATIONAL, 2012, 38 (07) :6035-6039

[48] Preparation of ZrO2(Y2O3)/Al2O3 composites by vacuum sintering [J].

Ma, WM ;

Sun, XD ;

Yang, HR ;

Wen, L ;

Guan, RG ;

Li, XK .

ACTA METALLURGICA SINICA, 2006, 42 (04) :431-436

[49] High temperature plastic anisotropy of Y2O3 partially stabilized ZrO2 single crystals [J].

Muñoz, A ;

García, DG ;

Domínguez-Rodríguez, A ;

Wakai, F .

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2002, 22 (14-15) :2609-2613

[50] Microstructure and fracture behaviour of ZrO2 (2 mol% Y2O3) reinforced with SiC whiskers [J].

F Ye ;

T. C Lei ;

Y. C Zhao ;

Y Zhou .

Journal of Materials Science, 1997, 32 :3249-3255

← 1 2 3 4 5 →